Re: [PATCH] ARM: imx6ul-14x14-evk: Do not reset the Ethernet PHYs independently
From: Andrew Lunn <andrew@lunn.ch>
Date: 2021-03-12 14:09:36
On Fri, Mar 12, 2021 at 08:37:46AM -0300, Fabio Estevam wrote:
The imx6ul-evk board designer took the bad decision to tie the
two Ethernet PHY reset lines together. This prevents one Ethernet
interface to work while the other one is brought down. For example:
# ifconfig eth0 down
# [ 279.386551] fec 2188000.ethernet eth1: Link is Down
Bringing eth0 interface down also causes eth1 to be down.
The Ethernet reset lines comes from the IO expander and both come in
logic level 0 by default.
To fix this issue, remove the Ethernet PHY reset descriptions from
its respective PHY nodes and force both Ethernet PHY lines to be at
logic level 1 via gpio-hog.
Fixes: 2db7e78bf02b ("ARM: dts: imx6ul-14x14-evk: Describe the KSZ8081 reset")
Reported-by: Joakim Zhang <redacted>
Signed-off-by: Fabio Estevam <festevam@gmail.com>
Reviewed-by: Andrew Lunn <andrew@lunn.ch>
Andrew
_______________________________________________
linux-arm-kernel mailing list
linux-arm-kernel@lists.infradead.org
http://lists.infradead.org/mailman/listinfo/linux-arm-kernel