The PRU firmware interrupt mappings are configured and unconfigured in
.start() and .stop() callbacks respectively using the variables 'evt_count'
and a 'mapped_irq' pointer. These variables are modified only during these
callbacks but are not re-initialized/reset properly during unwind or
failure paths. These stale values caused a kernel crash while stopping a
PRU remoteproc running a different firmware with no events on a subsequent
run after a previous run that was running a firmware with events.

Fix this crash by ensuring that the evt_count is 0 and the mapped_irq
pointer is set to NULL in pru_dispose_irq_mapping(). Also, reset these
variables properly during any failures in the .start() callback. While
at this, the pru_dispose_irq_mapping() callsites are all made to look
the same, moving any conditional logic to inside the function.

Fixes: c75c9fdac66e ("remoteproc: pru: Add support for PRU specific interrupt configuration")
Reported-by: Vignesh Raghavendra <vigneshr@ti.com>
Signed-off-by: Suman Anna <redacted>
---
 drivers/remoteproc/pru_rproc.c | 12 +++++++++---
 1 file changed, 9 insertions(+), 3 deletions(-)

diff --git a/drivers/remoteproc/pru_rproc.c b/drivers/remoteproc/pru_rproc.c
index 87b43976c51b..5df19acb90ed 100644
--- a/drivers/remoteproc/pru_rproc.c
+++ b/drivers/remoteproc/pru_rproc.c

@@ -266,12 +266,17 @@ static void pru_rproc_create_debug_entries(struct rproc *rproc)
 
 static void pru_dispose_irq_mapping(struct pru_rproc *pru)
 {
-	while (pru->evt_count--) {
+	if (!pru->mapped_irq)
+		return;
+
+	while (pru->evt_count) {
+		pru->evt_count--;
 		if (pru->mapped_irq[pru->evt_count] > 0)
 			irq_dispose_mapping(pru->mapped_irq[pru->evt_count]);
 	}
 
 	kfree(pru->mapped_irq);
+	pru->mapped_irq = NULL;
 }
 
 /*

@@ -324,6 +329,8 @@ static int pru_handle_intrmap(struct rproc *rproc)
 	of_node_put(parent);
 	if (!irq_parent) {
 		kfree(pru->mapped_irq);
+		pru->mapped_irq = NULL;
+		pru->evt_count = 0;
 		return -ENODEV;
 	}
 

@@ -398,8 +405,7 @@ static int pru_rproc_stop(struct rproc *rproc)
 	pru_control_write_reg(pru, PRU_CTRL_CTRL, val);
 
 	/* dispose irq mapping - new firmware can provide new mapping */
-	if (pru->mapped_irq)
-		pru_dispose_irq_mapping(pru);
+	pru_dispose_irq_mapping(pru);
 
 	return 0;
 }

-- 
2.30.1


_______________________________________________
linux-arm-kernel mailing list
linux-arm-kernel@lists.infradead.org
http://lists.infradead.org/mailman/listinfo/linux-arm-kernel