[PATCH v2 2/2] arm64: dts: ti: k3-am642-evm: Add USB support
From: Aswath Govindraju <hidden>
Date: 2021-03-10 11:30:05
Also in:
linux-devicetree, lkml
Subsystem:
arm/texas instruments k3 architecture, the rest · Maintainers:
Nishanth Menon, Vignesh Raghavendra, Tero Kristo, Linus Torvalds
AM64 EVM board has a micro USB 2.0 AB connector and the USB0_VBUS is connected with a resistor divider in between. USB0_DRVVBUS pin is muxed between USB0_DRVVBUS and GPIO1_79 signals. Add the corresponding properties and set the pinmux mode for USB subsystem in the evm dts file. Signed-off-by: Aswath Govindraju <redacted> Acked-by: Roger Quadros <redacted> --- arch/arm64/boot/dts/ti/k3-am642-evm.dts | 18 ++++++++++++++++++ 1 file changed, 18 insertions(+)
diff --git a/arch/arm64/boot/dts/ti/k3-am642-evm.dts b/arch/arm64/boot/dts/ti/k3-am642-evm.dts
index 962ef807e286..45fdcf3220a8 100644
--- a/arch/arm64/boot/dts/ti/k3-am642-evm.dts
+++ b/arch/arm64/boot/dts/ti/k3-am642-evm.dts@@ -201,6 +201,12 @@ AM64X_IOPAD(0x0144, PIN_OUTPUT, 4) /* (Y11) PRG1_PRU1_GPO15.RGMII2_TX_CTL */ >; }; + + main_usb0_pins_default: main-usb0-pins-default { + pinctrl-single,pins = < + AM64X_IOPAD(0x02a8, PIN_OUTPUT, 0) /* (E19) USB0_DRVVBUS */ + >; + }; }; &main_uart0 {
@@ -313,6 +319,18 @@ disable-wp; }; +&usbss0 { + ti,vbus-divider; + ti,usb2-only; +}; + +&usb0 { + dr_mode = "otg"; + maximum-speed = "high-speed"; + pinctrl-names = "default"; + pinctrl-0 = <&main_usb0_pins_default>; +}; + &cpsw3g { pinctrl-names = "default"; pinctrl-0 = <&mdio1_pins_default
--
2.17.1
_______________________________________________
linux-arm-kernel mailing list
linux-arm-kernel@lists.infradead.org
http://lists.infradead.org/mailman/listinfo/linux-arm-kernel