Re: [PATCH v2 3/3] arm64: dts: ti: k3-j7200-som-p0: Add nodes for OSPI0
From: Nishanth Menon <nm@ti.com>
Date: 2021-03-09 17:02:50
Also in:
linux-devicetree, lkml
On 21:09-20210305, Pratyush Yadav wrote:
TI J7200 has the Cadence OSPI controller for interfacing with OSPI
flashes. Add its node to allow using SPI flashes.
Signed-off-by: Pratyush Yadav <redacted>
---
Notes:
Changes in v2:
- Do not force a pulldown on the DQS line because it already has a
pulldown resistor.
.../boot/dts/ti/k3-j7200-mcu-wakeup.dtsi | 17 +++++++++
arch/arm64/boot/dts/ti/k3-j7200-som-p0.dtsi | 36 +++++++++++++++++++
2 files changed, 53 insertions(+)I see this with dtbs_check on v5.12-rc2: /workdir/arch/arm64/boot/dts/ti/k3-j7200-common-proc-board.dt.yaml: flash@0: 'cdns,read-delay', 'cdns,tchsh-ns', 'cdns,tsd2d-ns', 'cdns,tshsl-ns', 'cdns,tslch-ns' do not match any of the regexes: '^partition@', 'pinctrl-[0-9]+' -- Regards, Nishanth Menon Key (0xDDB5849D1736249D) / Fingerprint: F8A2 8693 54EB 8232 17A3 1A34 DDB5 849D 1736 249D _______________________________________________ linux-arm-kernel mailing list linux-arm-kernel@lists.infradead.org http://lists.infradead.org/mailman/listinfo/linux-arm-kernel