[PATCH v2 03/13] serial: stm32: fix incorrect characters on console
From: Erwan Le Ray <hidden>
Date: 2021-03-04 16:25:09
Also in:
linux-serial, lkml
Subsystem:
the rest, tty layer and serial drivers · Maintainers:
Linus Torvalds, Greg Kroah-Hartman, Jiri Slaby
Incorrect characters are observed on console during boot. This issue occurs
when init/main.c is modifying termios settings to open /dev/console on the
rootfs.
This patch adds a waiting loop in set_termios to wait for TX shift register
empty (and TX FIFO if any) before stopping serial port.
Fixes: 48a6092fb41f ("serial: stm32-usart: Add STM32 USART Driver")
Signed-off-by: Erwan Le Ray <redacted>
diff --git a/drivers/tty/serial/stm32-usart.c b/drivers/tty/serial/stm32-usart.c
index c6ca8f964c69..eae54b8cf5e2 100644
--- a/drivers/tty/serial/stm32-usart.c
+++ b/drivers/tty/serial/stm32-usart.c@@ -738,8 +738,9 @@ static void stm32_usart_set_termios(struct uart_port *port, unsigned int baud, bits; u32 usartdiv, mantissa, fraction, oversampling; tcflag_t cflag = termios->c_cflag; - u32 cr1, cr2, cr3; + u32 cr1, cr2, cr3, isr; unsigned long flags; + int ret; if (!stm32_port->hw_flow_control) cflag &= ~CRTSCTS;
@@ -748,6 +749,15 @@ static void stm32_usart_set_termios(struct uart_port *port, spin_lock_irqsave(&port->lock, flags); + ret = readl_relaxed_poll_timeout_atomic(port->membase + ofs->isr, + isr, + (isr & USART_SR_TC), + 10, 100000); + + /* Send the TC error message only when ISR_TC is not set. */ + if (ret) + dev_err(port->dev, "Transmission is not complete\n"); + /* Stop serial port and reset value */ writel_relaxed(0, port->membase + ofs->cr1);
--
2.17.1
_______________________________________________
linux-arm-kernel mailing list
linux-arm-kernel@lists.infradead.org
http://lists.infradead.org/mailman/listinfo/linux-arm-kernel