[PATCH 02/13] serial: stm32: fix startup by enabling usart for reception
From: Erwan Le Ray <hidden>
Date: 2021-02-19 17:49:25
Also in:
linux-serial, lkml
Subsystem:
the rest, tty layer and serial drivers · Maintainers:
Linus Torvalds, Greg Kroah-Hartman, Jiri Slaby
RX is configured, but usart is not enabled in startup function.
Kernel documentation specifies that startup should enable the port for
reception.
Fix the startup by enabling usart for reception.
Fixes: 84872dc448fe ("serial: stm32: add RX and TX FIFO flush")
Signed-off-by: Erwan Le Ray <redacted>
diff --git a/drivers/tty/serial/stm32-usart.c b/drivers/tty/serial/stm32-usart.c
index c67029ebcac8..33a479062948 100644
--- a/drivers/tty/serial/stm32-usart.c
+++ b/drivers/tty/serial/stm32-usart.c@@ -634,6 +634,7 @@ static int stm32_usart_startup(struct uart_port *port) { struct stm32_port *stm32_port = to_stm32_port(port); struct stm32_usart_offsets *ofs = &stm32_port->info->ofs; + struct stm32_usart_config *cfg = &stm32_port->info->cfg; const char *name = to_platform_device(port->dev)->name; u32 val; int ret;
@@ -658,7 +659,7 @@ static int stm32_usart_startup(struct uart_port *port) } /* RX FIFO enabling */ - val = stm32_port->cr1_irq | USART_CR1_RE; + val = stm32_port->cr1_irq | USART_CR1_RE | BIT(cfg->uart_enable_bit); if (stm32_port->fifoen) val |= USART_CR1_FIFOEN; stm32_usart_set_bits(port, ofs->cr1, val);
--
2.17.1
_______________________________________________
linux-arm-kernel mailing list
linux-arm-kernel@lists.infradead.org
http://lists.infradead.org/mailman/listinfo/linux-arm-kernel