[PATCH v4 0/3] J7200: Add support for GPIO and higher speed modes in MMCSD subsystems

The following series of patches
- Add support for GPIO subsystem in main and wakeup domains.
- Add voltage regulator device tree nodes and their corresponding pinmux
  to support power cycle and voltage switch required for UHS-I modes
- sets respective tags in sdhci0 node to support higher speeds
- remove no-1-8-v tag from sdhci1 node to support UHS-I modes

performance test logs using EXT4 filesystem
- For eMMC HS400 speed mode,
  https://pastebin.ubuntu.com/p/gDxBCwtkt8/  
- For SD SDR104 speed mode,
  https://pastebin.ubuntu.com/p/tHYTn2wxwg/  

Changes since v3:
- Removed patch (1 in v3).
- Rebased and included patches that add support for GPIO from series [1].
- Re-ran the performace tests for SD and eMMC.

Changes since v2:
- Added main_gpio0 DT node
- Added voltage regulator device tree nodes required to support UHS-I modes

Changes since v1:
- squashed the two patches into one
- added performance logs for the above mentioned speed modes

Aswath Govindraju (1):
  arm64: dts: ti: k3-j7200: Add support for higher speed modes in MMCSD
    subsystems

[1] - https://lkml.org/lkml/2020/11/17/1489

Faiz Abbas (2):
  arm64: dts: ti: k3-j7200: Add gpio nodes
  arm64: dts: ti: k3-j7200-common-proc-board: Disable unused gpio
    modules

 .../dts/ti/k3-j7200-common-proc-board.dts     | 47 ++++++++++++
 arch/arm64/boot/dts/ti/k3-j7200-main.dtsi     | 75 ++++++++++++++++++-
 .../boot/dts/ti/k3-j7200-mcu-wakeup.dtsi      | 34 +++++++++
 3 files changed, 155 insertions(+), 1 deletion(-)

-- 
2.17.1


_______________________________________________
linux-arm-kernel mailing list
linux-arm-kernel@lists.infradead.org
http://lists.infradead.org/mailman/listinfo/linux-arm-kernel