[PATCH v5 04/20] dt-bindings: mfd: axp20x: Add AXP305 compatible (plus optional IRQ)
From: Andre Przywara <andre.przywara@arm.com>
Date: 2021-01-27 17:27:45
Also in:
linux-devicetree, lkml
Subsystem:
multifunction devices (mfd), open firmware and flattened device tree bindings, the rest · Maintainers:
Lee Jones, Rob Herring, Krzysztof Kozlowski, Conor Dooley, Linus Torvalds
The AXP305 PMIC used in AXP805 seems to be fully compatible to the AXP805 PMIC, so add the proper chain of compatible strings. Also at least on one board (Orangepi Zero2) there is no interrupt line connected to the CPU, so make the "interrupts" property optional. Signed-off-by: Andre Przywara <andre.przywara@arm.com> --- Documentation/devicetree/bindings/mfd/axp20x.txt | 3 ++- 1 file changed, 2 insertions(+), 1 deletion(-)
diff --git a/Documentation/devicetree/bindings/mfd/axp20x.txt b/Documentation/devicetree/bindings/mfd/axp20x.txt
index 4991a6415796..4fd748101e3c 100644
--- a/Documentation/devicetree/bindings/mfd/axp20x.txt
+++ b/Documentation/devicetree/bindings/mfd/axp20x.txt@@ -26,10 +26,10 @@ Required properties: * "x-powers,axp803" * "x-powers,axp806" * "x-powers,axp805", "x-powers,axp806" + * "x-powers,axp803", "x-powers,axp805", "x-powers,axp806" * "x-powers,axp809" * "x-powers,axp813" - reg: The I2C slave address or RSB hardware address for the AXP chip -- interrupts: SoC NMI / GPIO interrupt connected to the PMIC's IRQ pin - interrupt-controller: The PMIC has its own internal IRQs - #interrupt-cells: Should be set to 1
@@ -43,6 +43,7 @@ more information: AXP20x/LDO3: software-based implementation Optional properties: +- interrupts: SoC NMI / GPIO interrupt connected to the PMIC's IRQ pin - x-powers,dcdc-freq: defines the work frequency of DC-DC in KHz AXP152/20X: range: 750-1875, Default: 1.5 MHz AXP22X/8XX: range: 1800-4050, Default: 3 MHz
--
2.17.5
_______________________________________________
linux-arm-kernel mailing list
linux-arm-kernel@lists.infradead.org
http://lists.infradead.org/mailman/listinfo/linux-arm-kernel