[PATCH v2 03/11] dt-bindings:iio:adc:remove atmel, adc-res and atmel, adc-res-names
From: Alexandre Belloni <alexandre.belloni@bootlin.com>
Date: 2020-11-17 14:08:36
Also in:
linux-devicetree, linux-iio, lkml
Subsystem:
iio subsystem and drivers, open firmware and flattened device tree bindings, the rest · Maintainers:
Jonathan Cameron, Rob Herring, Krzysztof Kozlowski, Conor Dooley, Linus Torvalds
Remove atmel,adc-res and atmel,adc-res-names as they are not necessary and are handled by the driver. Also add sama5d3 to the list of possible chips. Cc: Rob Herring <robh+dt@kernel.org> Signed-off-by: Alexandre Belloni <alexandre.belloni@bootlin.com> --- .../devicetree/bindings/iio/adc/at91_adc.txt | 13 ++++--------- 1 file changed, 4 insertions(+), 9 deletions(-)
diff --git a/Documentation/devicetree/bindings/iio/adc/at91_adc.txt b/Documentation/devicetree/bindings/iio/adc/at91_adc.txt
index f65b04fb7962..da393ac5c05f 100644
--- a/Documentation/devicetree/bindings/iio/adc/at91_adc.txt
+++ b/Documentation/devicetree/bindings/iio/adc/at91_adc.txt@@ -2,7 +2,7 @@ Required properties: - compatible: Should be "atmel,<chip>-adc" - <chip> can be "at91sam9260", "at91sam9g45" or "at91sam9x5" + <chip> can be "at91sam9260", "at91sam9g45", "at91sam9x5" or "sama5d3" - reg: Should contain ADC registers location and length - interrupts: Should contain the IRQ line for the ADC - clock-names: tuple listing input clock names.
@@ -13,17 +13,12 @@ Required properties: - atmel,adc-startup-time: Startup Time of the ADC in microseconds as defined in the datasheet - atmel,adc-vref: Reference voltage in millivolts for the conversions - - atmel,adc-res: List of resolutions in bits supported by the ADC. List size - must be two at least. - - atmel,adc-res-names: Contains one identifier string for each resolution - in atmel,adc-res property. "lowres" and "highres" - identifiers are required. Optional properties: - atmel,adc-use-external-triggers: Boolean to enable the external triggers - - atmel,adc-use-res: String corresponding to an identifier from - atmel,adc-res-names property. If not specified, the highest - resolution will be used. + - atmel,adc-use-res: String selecting the resolution, can be "lowres" or + "highres". If not specified, the highest resolution will + be used. - atmel,adc-sleep-mode: Boolean to enable sleep mode when no conversion - atmel,adc-sample-hold-time: Sample and Hold Time in microseconds - atmel,adc-ts-wires: Number of touchscreen wires. Should be 4 or 5. If this
--
2.28.0
_______________________________________________
linux-arm-kernel mailing list
linux-arm-kernel@lists.infradead.org
http://lists.infradead.org/mailman/listinfo/linux-arm-kernel