[PATCH v2] pinctrl: aspeed: Fix GPI only function problem.
From: Billy Tsai <hidden>
Date: 2020-10-30 05:55:46
Also in:
linux-aspeed, linux-gpio, openbmc
Subsystem:
aspeed pinctrl drivers, pin control subsystem, the rest · Maintainers:
Andrew Jeffery, Linus Walleij, Linus Torvalds
Some gpio pin at aspeed soc is input only and the prefix name of these
pin is "GPI" only.
This patch fine-tune the condition of GPIO check from "GPIO" to "GPI"
and it will fix the usage error of banks D and E in the AST2400/AST2500
and banks T and U in the AST2600.
Fixes: 4d3d0e4272d8 ("pinctrl: Add core support for Aspeed SoCs")
Signed-off-by: Billy Tsai <redacted>
---
drivers/pinctrl/aspeed/pinctrl-aspeed.c | 7 ++++---
1 file changed, 4 insertions(+), 3 deletions(-)
diff --git a/drivers/pinctrl/aspeed/pinctrl-aspeed.c b/drivers/pinctrl/aspeed/pinctrl-aspeed.c
index e03ee78b2434..95c8d400ad59 100644
--- a/drivers/pinctrl/aspeed/pinctrl-aspeed.c
+++ b/drivers/pinctrl/aspeed/pinctrl-aspeed.c@@ -286,13 +286,14 @@ int aspeed_pinmux_set_mux(struct pinctrl_dev *pctldev, unsigned int function, static bool aspeed_expr_is_gpio(const struct aspeed_sig_expr *expr) { /* - * The signal type is GPIO if the signal name has "GPIO" as a prefix. + * The signal type is GPIO if the signal name has "GPI" as a prefix. * strncmp (rather than strcmp) is used to implement the prefix * requirement. * - * expr->signal might look like "GPIOT3" in the GPIO case. + * expr->signal might look like "GPIOB1" in the GPIO case. + * expr->signal might look like "GPIT0" in the GPI case. */ - return strncmp(expr->signal, "GPIO", 4) == 0; + return strncmp(expr->signal, "GPI", 3) == 0; } static bool aspeed_gpio_in_exprs(const struct aspeed_sig_expr **exprs)
--
2.17.1
_______________________________________________
linux-arm-kernel mailing list
linux-arm-kernel@lists.infradead.org
http://lists.infradead.org/mailman/listinfo/linux-arm-kernel