Neil Armstrong [off-list ref] writes:

Hi Kevin,

On 17/09/2020 08:59, Neil Armstrong wrote:

quoted

The Amlogic AXG is close to the GXL Glue but with a single OTG PHY.

It needs the same init sequence as GXL & GXM, but it seems it doesn't need
the host disconnect bit.

The Glue driver reuses the already implemented GXL & GXM work.

The USB2 PHY driver needs a slight tweak to keep the OTG detection working.

Changes since v1 at [1]:
- s/close from/close to/g
- collected review tags
- added small comment about phy management in patch 3
- removed status = "okay" in patch 4
- removed invalid phy-supply of phy1 in patch 5

[1] http://lore.kernel.org/r/20200909160409.8678-1-narmstrong@baylibre.com (local)

Neil Armstrong (5):
  phy: amlogic: phy-meson-gxl-usb2: keep ID pull-up even in Host mode
  dt-bindings: usb: amlogic,meson-g12a-usb-ctrl: add the Amlogic AXG
    Families USB Glue Bindings
  usb: dwc-meson-g12a: Add support for USB on AXG SoCs
  arm64: dts: meson-axg: add USB nodes
  arm64: dts: meson-axg-s400: enable USB OTG

Can you pick the DT patches ?

Yes, queued up.

Since we're already at -rc7, this may not make it until v5.11.

Kevin

_______________________________________________
linux-arm-kernel mailing list
linux-arm-kernel@lists.infradead.org
http://lists.infradead.org/mailman/listinfo/linux-arm-kernel