On 30.07.2020 14:28, Sylwester Nawrocki wrote:

On 09.07.2020 23:04, Rob Herring wrote:

quoted

On Thu, Jul 02, 2020 at 06:37:19PM +0200, Sylwester Nawrocki wrote:

quoted

Add documentation for new optional properties in the exynos bus nodes:
samsung,interconnect-parent, #interconnect-cells, bus-width.
These properties allow to specify the SoC interconnect structure which
then allows the interconnect consumer devices to request specific
bandwidth requirements.

Signed-off-by: Artur Świgoń <a.swigon@samsung.com>
Signed-off-by: Sylwester Nawrocki <s.nawrocki@samsung.com>

quoted

quoted

--- a/Documentation/devicetree/bindings/devfreq/exynos-bus.txt
+++ b/Documentation/devicetree/bindings/devfreq/exynos-bus.txt

@@ -51,6 +51,13 @@ Optional properties only for parent bus device:
 - exynos,saturation-ratio: the percentage value which is used to calibrate
 			the performance count against total cycle count.
 
+Optional properties for interconnect functionality (QoS frequency constraints):
+- samsung,interconnect-parent: phandle to the parent interconnect node; for
+  passive devices should point to same node as the exynos,parent-bus property.

quoted

Adding vendor specific properties for a common binding defeats the 
point.

Actually we could do without any new property if we used existing interconnect
consumers binding to specify linking between the provider nodes. I think those
exynos-bus nodes could well be considered both the interconnect providers 
and consumers. The example would then be something along the lines 
(yes, I know the bus node naming needs to be fixed):

	soc {
		bus_dmc: bus_dmc {
			compatible = "samsung,exynos-bus";
			/* ... */
			samsung,data-clock-ratio = <4>;
			#interconnect-cells = <0>;
		};

		bus_leftbus: bus_leftbus {
			compatible = "samsung,exynos-bus";
			/* ... */
			interconnects = <&bus_leftbus &bus_dmc>;
			#interconnect-cells = <0>;
		};

		bus_display: bus_display {
			compatible = "samsung,exynos-bus";
			/* ... */
			interconnects = <&bus_display &bus_leftbus>;
			#interconnect-cells = <0>;
		};


		&mixer {
			compatible = "samsung,exynos4212-mixer";
			interconnects = <&bus_display &bus_dmc>;
			/* ... */
		};
	};

What do you think, Georgi, Rob?

-- 
Regards
Sylwester

_______________________________________________
linux-arm-kernel mailing list
linux-arm-kernel@lists.infradead.org
http://lists.infradead.org/mailman/listinfo/linux-arm-kernel