Re: [PATCH v5 4/9] ARM: dts: bcm2711: Add reset controller to xHCI node
From: Florian Fainelli <f.fainelli@gmail.com>
Date: 2020-06-29 21:18:31
Also in:
linux-pci, linux-usb, lkml
On 6/29/2020 9:18 AM, Nicolas Saenz Julienne wrote:
The chip is hardwired to the board's PCIe bus and needs to be properly setup trough a firmware routine after a PCI fundamental reset. Pass the reset controller phandle that takes care of triggering the initialization to the relevant PCI device. Signed-off-by: Nicolas Saenz Julienne <redacted>
Reviewed-by: Florian Fainelli <f.fainelli@gmail.com> -- Florian _______________________________________________ linux-arm-kernel mailing list linux-arm-kernel@lists.infradead.org http://lists.infradead.org/mailman/listinfo/linux-arm-kernel