RE: [PATCH V5 1/9] pinctrl: imx: Support building SCU pinctrl driver as module
From: Aisheng Dong <aisheng.dong@nxp.com>
Date: 2020-06-17 10:29:53
Also in:
linux-gpio, lkml
[...]
quoted
quoted
quoted
quoted
- * @dev: a pointer back to containing device - * @base: the offset to the controller in virtual memory - */ -struct imx_pinctrl { - struct device *dev; - struct pinctrl_dev *pctl; - void __iomem *base; - void __iomem *input_sel_base; - const struct imx_pinctrl_soc_info *info; - struct imx_pin_reg *pin_regs; - unsigned int group_index; - struct mutex mutex; + int (*imx_pinconf_get)(struct pinctrl_dev *pctldev, unsigned +intpin_id,quoted
quoted
quoted
+ unsigned long *config); + int (*imx_pinconf_set)(struct pinctrl_dev *pctldev, unsigned +intpin_id,quoted
quoted
quoted
+ unsigned long *configs, unsigned int num_configs); + void (*imx_pinctrl_parse_pin)(struct imx_pinctrl *ipctl, + unsigned int *pin_id, struct imx_pin *pin, + const __be32 **list_p);Compared with V4, this new implementation seems a bit complicated. I guess we don't have to support PINCTRL_IMX=y && PINCTRL_IMX_SCU=m case. Will that make the support a bit easier?I am NOT sure if such scenario meets requirement, the fact is other non-i.MX SoC also selects the PINCTRL_IMX which will make PINCTRL_IMX=y, so in that case, even all i.MX PINCTRL drivers are set to module, it will still have PINCTRL_IMX=y and PINCTRL_IMX_SCU=m, then build will fail. And I believe the auto build test may also cover such case and build error will be reported, that is why this change is needed and with this change, function is NOT impacted,Is it possible to add some constrainst to make sure PINCTRL_IMX_SCU value is the same as PINCTRL_IMX? Or combine them into one? If we can do that, it may ease the implementation a lot and make the code still clean.Combine PINCTRL_IMX_SCU and PINCTRL_IMX is NOT making sense, since for non-SCU platforms, PINCTRL_IMX_SCU is NOT necessary, to make PINCTRL_IMX_SCU same value as PINCTRL_IMX, unless make "select PINCTRL_IMX_SCU" in PINCTRL_IMX, but that is also NOT making sense, because, PINCTRL_IMX does NOT depends on PINCTRL_IMX_SCU at all.
PINCTRL_IMX_SCU could be conditionally compiled. Something like follows: obj-$(CONFIG_PINCTRL_IMX) += pinctrl-imx-core.o pinctrl-imx-core-y := pinctrl-imx.o pinctrl-imx-core-$(CONFIG_PINCTRL_IMX_SCU) += pinctrl-scu.o Can you try if this way could work? Regards Aisheng
The change is NOT that big IMO, and no better idea in my mind, have tried that in previous versions of patch series. Anson
_______________________________________________ linux-arm-kernel mailing list linux-arm-kernel@lists.infradead.org http://lists.infradead.org/mailman/listinfo/linux-arm-kernel