[PATCH v3 1/8] dt-bindings: net: meson-dwmac: Add the amlogic, rx-delay-ns property
From: Martin Blumenstingl <martin.blumenstingl@googlemail.com>
Date: 2020-05-12 21:11:23
Also in:
linux-amlogic, linux-devicetree, lkml, netdev
Subsystem:
networking drivers, open firmware and flattened device tree bindings, the rest · Maintainers:
Andrew Lunn, "David S. Miller", Eric Dumazet, Jakub Kicinski, Paolo Abeni, Rob Herring, Krzysztof Kozlowski, Conor Dooley, Linus Torvalds
The PRG_ETHERNET registers on Meson8b and newer SoCs can add an RX delay. Add a property with the known supported values so it can be configured according to the board layout. Reviewed-by: Andrew Lunn <andrew@lunn.ch> Signed-off-by: Martin Blumenstingl <martin.blumenstingl@googlemail.com> --- .../bindings/net/amlogic,meson-dwmac.yaml | 13 +++++++++++++ 1 file changed, 13 insertions(+)
diff --git a/Documentation/devicetree/bindings/net/amlogic,meson-dwmac.yaml b/Documentation/devicetree/bindings/net/amlogic,meson-dwmac.yaml
index ae91aa9d8616..66074314e57a 100644
--- a/Documentation/devicetree/bindings/net/amlogic,meson-dwmac.yaml
+++ b/Documentation/devicetree/bindings/net/amlogic,meson-dwmac.yaml@@ -67,6 +67,19 @@ allOf: PHY and MAC are adding a delay). Any configuration is ignored when the phy-mode is set to "rmii". + amlogic,rx-delay-ns: + enum: + - 0 + - 2 + default: 0 + description: + The internal RGMII RX clock delay (provided by this IP block) in + nanoseconds. When phy-mode is set to "rgmii" then the RX delay + should be explicitly configured. When the phy-mode is set to + either "rgmii-id" or "rgmii-rxid" the RX clock delay is already + provided by the PHY. Any configuration is ignored when the + phy-mode is set to "rmii". + properties: compatible: additionalItems: true
--
2.26.2
_______________________________________________
linux-arm-kernel mailing list
linux-arm-kernel@lists.infradead.org
http://lists.infradead.org/mailman/listinfo/linux-arm-kernel