[PATCH v3 08/12] mtd: spi-nor: use dummy cycle and address width info from SFDP
From: Pratyush Yadav <hidden>
Date: 2020-03-13 15:47:38
Also in:
linux-spi, lkml
Subsystem:
memory technology devices (mtd), spi nor subsystem, the rest · Maintainers:
Miquel Raynal, Richard Weinberger, Vignesh Raghavendra, Pratyush Yadav, Michael Walle, Linus Torvalds
The xSPI Profile 1.0 table specifies how many dummy cycles and address bytes are needed for the Read Status Register command in octal DTR mode. Use that information to send the correct Read SR command. Signed-off-by: Pratyush Yadav <redacted> --- drivers/mtd/spi-nor/spi-nor.c | 17 +++++++++++++++-- 1 file changed, 15 insertions(+), 2 deletions(-)
diff --git a/drivers/mtd/spi-nor/spi-nor.c b/drivers/mtd/spi-nor/spi-nor.c
index efa3b01030f5..16d7516f2470 100644
--- a/drivers/mtd/spi-nor/spi-nor.c
+++ b/drivers/mtd/spi-nor/spi-nor.c@@ -578,6 +578,8 @@ static int spi_nor_write_disable(struct spi_nor *nor) static int spi_nor_read_sr(struct spi_nor *nor, u8 *sr) { int ret; + u8 addr_bytes = nor->params.rdsr_addr_nbytes; + u8 dummy = nor->params.rdsr_dummy; if (nor->spimem) { struct spi_mem_op op =
@@ -586,10 +588,21 @@ static int spi_nor_read_sr(struct spi_nor *nor, u8 *sr) SPI_MEM_OP_NO_DUMMY, SPI_MEM_OP_DATA_IN(1, sr, 1)); + if (spi_nor_protocol_is_dtr(nor->reg_proto)) { + op.addr.nbytes = addr_bytes; + op.addr.val = 0; + op.dummy.nbytes = dummy; + } + + spi_nor_spimem_setup_op(nor, &op, nor->reg_proto); + ret = spi_mem_exec_op(nor->spimem, &op); } else { - ret = nor->controller_ops->read_reg(nor, SPINOR_OP_RDSR, - sr, 1); + if (spi_nor_protocol_is_dtr(nor->reg_proto)) + ret = -ENOTSUPP; + else + ret = nor->controller_ops->read_reg(nor, SPINOR_OP_RDSR, + sr, 1); } if (ret)
--
2.25.0
_______________________________________________
linux-arm-kernel mailing list
linux-arm-kernel@lists.infradead.org
http://lists.infradead.org/mailman/listinfo/linux-arm-kernel