On 21/02/2020 02:59, Jun Li wrote:

Neil Armstrong [off-list ref] 于2020年2月19日周三 下午10:18写道：

quoted

In certain circumstances, the XHCI SuperSpeed instance in park mode
can fail to recover, thus on Amlogic G12A/G12B/SM1 SoCs when there is high
load on the single XHCI SuperSpeed instance, the controller can crash like:
 xhci-hcd xhci-hcd.0.auto: xHCI host not responding to stop endpoint command.
 xhci-hcd xhci-hcd.0.auto: Host halt failed, -110
 xhci-hcd xhci-hcd.0.auto: xHCI host controller not responding, assume dead
 xhci-hcd xhci-hcd.0.auto: xHCI host not responding to stop endpoint command.
 hub 2-1.1:1.0: hub_ext_port_status failed (err = -22)
 xhci-hcd xhci-hcd.0.auto: HC died; cleaning up
 usb 2-1.1-port1: cannot reset (err = -22)

Setting the PARKMODE_DISABLE_SS bit in the DWC3_USB3_GUCTL1 mitigates
the issue. The bit is described as :
"When this bit is set to '1' all SS bus instances in park mode are disabled"

Synopsys explains in [1]:
The GUCTL1.PARKMODE_DISABLE_SS is only available in
dwc_usb3 controller running in host mode.
This should not be set for other IPs.
This can be disabled by default based on IP, but I recommend to have a
property to enable this feature for devices that need this.

[1] https://lore.kernel.org/linux-usb/45212db9-e366-2669-5c0a-3c5bd06287f6@synopsys.com (local)

This is not for gadget, patch title should be:

usb: dwc3: core: add support...

Li Jun

Indeed... time for a v4.

Thanks,

Neil

_______________________________________________
linux-arm-kernel mailing list
linux-arm-kernel@lists.infradead.org
http://lists.infradead.org/mailman/listinfo/linux-arm-kernel