Am Dienstag, 28. Januar 2020, 16:28:44 CET schrieb Robin Murphy:

On 28/01/2020 10:02 am, Heiko Stuebner wrote:

quoted

From: Heiko Stuebner <redacted>

Instead of open coding the polling of the lock status, use the
handy readl_poll_timeout for this. As the pll locking is normally
blazingly fast and we don't want to incur additional delays, we're
not doing any sleeps similar to for example the imx clk-pllv4
and define a very safe but still short timeout of 1ms.

Suggested-by: Stephen Boyd <sboyd@kernel.org>
Signed-off-by: Heiko Stuebner <redacted>
---
  drivers/clk/rockchip/clk-pll.c | 21 ++++++++++-----------
  1 file changed, 10 insertions(+), 11 deletions(-)

diff --git a/drivers/clk/rockchip/clk-pll.c b/drivers/clk/rockchip/clk-pll.c
index 198417d56300..43c9fd0086a2 100644
--- a/drivers/clk/rockchip/clk-pll.c
+++ b/drivers/clk/rockchip/clk-pll.c

@@ -585,19 +585,18 @@ static const struct clk_ops rockchip_rk3066_pll_clk_ops = {
  static int rockchip_rk3399_pll_wait_lock(struct rockchip_clk_pll *pll)
  {
  	u32 pllcon;
-	int delay = 24000000;
+	int ret;
  
-	/* poll check the lock status in rk3399 xPLLCON2 */
-	while (delay > 0) {
-		pllcon = readl_relaxed(pll->reg_base + RK3399_PLLCON(2));
-		if (pllcon & RK3399_PLLCON2_LOCK_STATUS)
-			return 0;
+	/*
+	 * Lock time typical 250, max 500 input clock cycles @24MHz
+	 * So define a very safe maximum of 1000us, meaning 24000 cycles.
+	 */
+	ret = readl_poll_timeout(pll->reg_base + RK3399_PLLCON(2), pllcon,
+				 pllcon & RK3399_PLLCON2_LOCK_STATUS, 0, 1000);

Note that the existing I/O accessor was readl_relaxed(), but using plain 
readl_poll_timeout() switches it to regular readl(). It may well not 
matter, but since it's not noted as an intentional change it seemed 
worth pointing out.

So we end up with an additional __iormb() after each readl_relaxed call.
So except for a small speed-penalty per iteration is there some other
memory-barrier wirednes that could come into play? (Somehow I always
forget the contents of Will's memory-barrier talks after a time)


From a bit of non-scientific testing, rk3328 seems to need at max 20
iterations in the wait_lock loop for the pll to lock, when doing cpufreq
scaling.

While interestingly px30 takes somewhere between 900 and 2000 iterations
on the same pll type.
[Though sleeps are not really possible anyway due to pll rates also getting
set during of_clk_register early during boot which results in errors about
scheduling the idle thread, so in the end it doesn't really matter]

Heiko



_______________________________________________
linux-arm-kernel mailing list
linux-arm-kernel@lists.infradead.org
http://lists.infradead.org/mailman/listinfo/linux-arm-kernel