Hi Florian,
hi Stephen,

Am 13.06.19 um 05:31 schrieb Florian Fainelli:

On 6/12/2019 11:24 AM, Nicolas Saenz Julienne wrote:

quoted

Hi all,
this aims at adding cpufreq support to the Raspberry Pi family of
boards.

The series first factors out 'pllb' from clk-bcm2385 and creates a new
clk driver that operates it over RPi's firmware interface[1]. We are
forced to do so as the firmware 'owns' the pll and we're not allowed to
change through the register interface directly as we might race with the
over-temperature and under-voltage protections provided by the firmware.

Next it creates a minimal cpufreq driver that populates the CPU's opp
table, and registers cpufreq-dt. Which is needed as the firmware
controls the max and min frequencies available.

This was tested on a RPi3b+ and RPI2b, both using multi_v7_defconfig and
arm64's defconfig.

How do we go about merging this? Stefan, will you pick up patch 3, 6 and
7 and submit them for 5.3/5.4? Viresh has already picked up patch 4.

is it possible to let patches 1,2, 3 and 5 go via clk-tree?

I would take care of 6 and 7.

Stefan

quoted

That's all,
kind regards,
Nicolas

[1] https://github.com/raspberrypi/firmware/wiki/Mailbox-property-interface

---

Changes since v3:
  - Fix sparse warnings in clk-raspberrypi.c
  - Minor cleanups

Changes since v2:
  - Fixed configs to match Stefan's comments
  - Round OPP frequencies
  - Rebase onto linux-next
  - Minor cleanups & checkpatch.pl

Changes since v1:
  - Enabled by default on the whole family of devices
  - Added/Fixed module support
  - clk device now registered by firmware driver
  - raspberrypi-cpufreq device now registered by clk driver
  - Reimplemented clk rounding unsing determine_rate()
  - Enabled in configs for arm and arm64

Changes since RFC:
  - Move firmware clk device into own driver

Nicolas Saenz Julienne (7):
  clk: bcm2835: remove pllb
  clk: bcm283x: add driver interfacing with Raspberry Pi's firmware
  firmware: raspberrypi: register clk device
  cpufreq: add driver for Raspberry Pi
  clk: raspberrypi: register platform device for raspberrypi-cpufreq
  ARM: defconfig: enable cpufreq driver for RPi
  arm64: defconfig: enable cpufreq support for RPi3

 arch/arm/configs/bcm2835_defconfig    |   9 +
 arch/arm/configs/multi_v7_defconfig   |   2 +
 arch/arm64/configs/defconfig          |   2 +
 drivers/clk/bcm/Kconfig               |   7 +
 drivers/clk/bcm/Makefile              |   1 +
 drivers/clk/bcm/clk-bcm2835.c         |  28 +--
 drivers/clk/bcm/clk-raspberrypi.c     | 315 ++++++++++++++++++++++++++
 drivers/cpufreq/Kconfig.arm           |   8 +
 drivers/cpufreq/Makefile              |   1 +
 drivers/cpufreq/raspberrypi-cpufreq.c |  97 ++++++++
 drivers/firmware/raspberrypi.c        |  10 +
 11 files changed, 456 insertions(+), 24 deletions(-)
 create mode 100644 drivers/clk/bcm/clk-raspberrypi.c
 create mode 100644 drivers/cpufreq/raspberrypi-cpufreq.c

_______________________________________________
linux-arm-kernel mailing list
linux-arm-kernel@lists.infradead.org
http://lists.infradead.org/mailman/listinfo/linux-arm-kernel