On Thu, Mar 14, 2019 at 12:31 AM Maxime Ripard
[off-list ref] wrote:

Hi Tomasz,

On Fri, Mar 08, 2019 at 03:12:18PM +0900, Tomasz Figa wrote:

quoted

quoted

+.. _v4l2-mpeg-h264:
+
+``V4L2_CID_MPEG_VIDEO_H264_SPS (struct)``
+    Specifies the sequence parameter set (as extracted from the
+    bitstream) for the associated H264 slice data. This includes the
+    necessary parameters for configuring a stateless hardware decoding
+    pipeline for H264.  The bitstream parameters are defined according
+    to :ref:`h264`. Unless there's a specific comment, refer to the
+    specification for the documentation of these fields, section 7.4.2.1.1
+    "Sequence Parameter Set Data Semantics".

I don't see this section being added by this patch. Where does it come from?

This is referring to the the H264 spec itself, as I was trying to
point out with the reference in that paragraph. How would you write
this down to make it more obvious?

Aha, somehow it didn't come to my mind when reading it. How about
something like below?

Unless there is a specific comment, refer to the ITU-T Rec. H.264
specification, section "7.4.2.1.1 Sequence parameter set data semantics"
(as of the 04/2017 edition).

Best regards,
Tomasz

_______________________________________________
linux-arm-kernel mailing list
linux-arm-kernel@lists.infradead.org
http://lists.infradead.org/mailman/listinfo/linux-arm-kernel