Re: [RFC PATCH v4 13/13] soc: ti: am6: Enable interrupt controller drivers
From: Nishanth Menon <nm@ti.com>
Date: 2019-01-15 13:55:52
Also in:
linux-devicetree, lkml
On 11:43-20181227, Lokesh Vutla wrote:
quoted hunk ↗ jump to hunk
Select all the TISCI dependent interrupt controller drivers for AM6 SoC. Suggested-by: Marc Zyngier <redacted> Signed-off-by: Lokesh Vutla <redacted> --- drivers/soc/ti/Kconfig | 5 +++++ 1 file changed, 5 insertions(+)diff --git a/drivers/soc/ti/Kconfig b/drivers/soc/ti/Kconfig index 7640490c2a6a..145b701a3d96 100644 --- a/drivers/soc/ti/Kconfig +++ b/drivers/soc/ti/Kconfig@@ -5,6 +5,11 @@ if ARCH_K3 config ARCH_K3_AM6_SOC bool "K3 AM6 SoC" + select MAILBOX + select TI_MESSAGE_MANAGER + select TI_SCI_PROTOCOL + select TI_SCI_INTR_IRQCHIP + select TI_SCI_INTA_IRQCHIP
Sorry for joining the party late.. but just 2 cents for thought.. Is'nt imply better than select here? for a very tiny kernel, it is possible to boot kernel up and TISCI and mailbox could be modules as well.. I know it is a theoretical concept, but it may be helpful (esp during pre-silicon time frame, at least during start, I usually start with almost everything other than the CPU cores and PSCI disabled). there is not much you can do with it ofcourse, but it helps me with a clean start.
help Enable support for TI's AM6 SoC Family support -- 2.19.2
-- Regards, Nishanth Menon _______________________________________________ linux-arm-kernel mailing list linux-arm-kernel@lists.infradead.org http://lists.infradead.org/mailman/listinfo/linux-arm-kernel