Re: [PATCH 0/8] Add IPROC I2C slave mode and NIC I2C support

You sent out the same patch series 3 times without any explanation. Very
confusing.

Is this the latest one that should be reviewed?

Thanks,

Ray

On 1/8/2019 1:16 AM, Rayagonda Kokatanur wrote:

Hi,
This patchset contains support for IPROC I2C slave and NIC I2C support.
Following are the brief changes done inorder to support both IPROC I2C
slave mode and NIC I2C,

a. Add support to allow I2C rx transfer upto 255 bytes
b. Add polling mode support to the iProc I2C driver. Polling mode is used
   in certain SoCs where interrupt is not connected from the I2C block.
c. Add warpper read/write access for register to support indirect register
   access. This is required in certain SoCs with this iProc I2C
   block registered.


Ray Jui (1):
  dt-bindings: i2c: iproc: make 'interrupts' optional

Rayagonda Kokatanur (5):
  i2c: iproc: add polling support
  i2c: iproc: use wrapper for read/write access
  dt-bindings: i2c: iproc: add "brcm,iproc-nic-i2c" compatible string
  i2c: iproc: add NIC I2C support
  arm64: dts: Stingray: Add NIC i2c device node

Shreesha Rajashekar (2):
  i2c: iproc: I2C read up to 255 bytes support
  i2c: iproc: Add Slave mode support

 .../devicetree/bindings/i2c/brcm,iproc-i2c.txt     |  14 +-
 .../arm64/boot/dts/broadcom/stingray/stingray.dtsi |  18 +
 drivers/i2c/busses/Kconfig                         |   1 +
 drivers/i2c/busses/i2c-bcm-iproc.c                 | 767 +++++++++++++++++----
 4 files changed, 669 insertions(+), 131 deletions(-)

_______________________________________________
linux-arm-kernel mailing list
linux-arm-kernel@lists.infradead.org
http://lists.infradead.org/mailman/listinfo/linux-arm-kernel