[PATCH] gpio: mvebu: only fail on missing clk if pwm is actually to be used
From: Uwe Kleine-König <hidden>
Date: 2018-12-17 08:43:25
Also in:
linux-gpio, stable
Subsystem:
gpio subsystem, the rest · Maintainers:
Linus Walleij, Bartosz Golaszewski, Linus Torvalds
The gpio IP on Armada 370 at offset 0x18180 has neither a clk nor pwm
registers. So there is no need for a clk as the pwm isn't used anyhow.
So only check for the clk in the presence of the pwm registers. This fixes
a failure to probe the gpio driver for the above mentioned gpio device.
Fixes: 757642f9a584 ("gpio: mvebu: Add limited PWM support")
Signed-off-by: Uwe Kleine-König <redacted>
---
drivers/gpio/gpio-mvebu.c | 6 +++---
1 file changed, 3 insertions(+), 3 deletions(-)
diff --git a/drivers/gpio/gpio-mvebu.c b/drivers/gpio/gpio-mvebu.c
index 6e02148c208b..adc768f908f1 100644
--- a/drivers/gpio/gpio-mvebu.c
+++ b/drivers/gpio/gpio-mvebu.c@@ -773,9 +773,6 @@ static int mvebu_pwm_probe(struct platform_device *pdev, "marvell,armada-370-gpio")) return 0; - if (IS_ERR(mvchip->clk)) - return PTR_ERR(mvchip->clk); - /* * There are only two sets of PWM configuration registers for * all the GPIO lines on those SoCs which this driver reserves
@@ -786,6 +783,9 @@ static int mvebu_pwm_probe(struct platform_device *pdev, if (!res) return 0; + if (IS_ERR(mvchip->clk)) + return PTR_ERR(mvchip->clk); + /* * Use set A for lines of GPIO chip with id 0, B for GPIO chip * with id 1. Don't allow further GPIO chips to be used for PWM.
--
2.19.2
_______________________________________________
linux-arm-kernel mailing list
linux-arm-kernel@lists.infradead.org
http://lists.infradead.org/mailman/listinfo/linux-arm-kernel