Thread (14 messages) flat view 14 messages, 3 authors, 2018-11-27
STALE2840d

Revision v1 of 2 in this series.

Revisions (2)
  1. rfc [diff vs current]
  2. v1 current

[PATCH linux-next 10/10] net: ethernet: ti: cpsw: deprecate cpsw-phy-sel driver

From: grygorii.strashko@ti.com (Grygorii Strashko)
Date: 2018-11-26 00:16:09
Also in: linux-devicetree, linux-omap, lkml, netdev
Subsystem: networking drivers, the rest, ti ethernet switch driver (cpsw) · Maintainers: Andrew Lunn, "David S. Miller", Eric Dumazet, Jakub Kicinski, Paolo Abeni, Linus Torvalds

Deprecate cpsw-phy-sel driver as it's been replaced with new
TI phy-gmii-sel PHY driver.

Cc: Kishon Vijay Abraham I <redacted>
Cc: Tony Lindgren <tony@atomide.com>
Signed-off-by: Grygorii Strashko <grygorii.strashko@ti.com>
---
 drivers/net/ethernet/ti/Kconfig | 6 +++---
 drivers/net/ethernet/ti/cpsw.h  | 6 ++++++
 2 files changed, 9 insertions(+), 3 deletions(-)
diff --git a/drivers/net/ethernet/ti/Kconfig b/drivers/net/ethernet/ti/Kconfig
index f932923..96415da 100644
--- a/drivers/net/ethernet/ti/Kconfig
+++ b/drivers/net/ethernet/ti/Kconfig
@@ -49,10 +49,11 @@ config TI_DAVINCI_CPDMA
 	  will be called davinci_cpdma.  This is recommended.
 
 config TI_CPSW_PHY_SEL
-	bool
+	bool "TI CPSW Phy mode Selection (DEPRECATED)"
+	default n
 	---help---
 	  This driver supports configuring of the phy mode connected to
-	  the CPSW.
+	  the CPSW. DEPRECATED: use PHY_TI_GMII_SEL.
 
 config TI_CPSW_ALE
 	tristate "TI CPSW ALE Support"
@@ -64,7 +65,6 @@ config TI_CPSW
 	depends on ARCH_DAVINCI || ARCH_OMAP2PLUS || COMPILE_TEST
 	select TI_DAVINCI_CPDMA
 	select TI_DAVINCI_MDIO
-	select TI_CPSW_PHY_SEL
 	select TI_CPSW_ALE
 	select MFD_SYSCON
 	select REGMAP
diff --git a/drivers/net/ethernet/ti/cpsw.h b/drivers/net/ethernet/ti/cpsw.h
index cf111db..907e05fc 100644
--- a/drivers/net/ethernet/ti/cpsw.h
+++ b/drivers/net/ethernet/ti/cpsw.h
@@ -21,7 +21,13 @@
 			 ((mac)[2] << 16) | ((mac)[3] << 24))
 #define mac_lo(mac)	(((mac)[4] << 0) | ((mac)[5] << 8))
 
+#if IS_ENABLED(CONFIG_TI_CPSW_PHY_SEL)
 void cpsw_phy_sel(struct device *dev, phy_interface_t phy_mode, int slave);
+#else
+static inline
+void cpsw_phy_sel(struct device *dev, phy_interface_t phy_mode, int slave)
+{}
+#endif
 int ti_cm_get_macid(struct device *dev, int slave, u8 *mac_addr);
 
 #endif /* __CPSW_H__ */
-- 
2.10.5
Keyboard shortcuts
hback out one level
jnext message in thread
kprevious message in thread
ldrill in
Escclose help / fold thread tree
?toggle this help