On 9/25/2018 1:27 AM, Wolfram Sang wrote:

On Mon, Sep 24, 2018 at 03:15:46PM -0700, Jae Hyun Yoo wrote:

quoted

Hi Wolfram,

On 9/24/2018 2:58 PM, Wolfram Sang wrote:

quoted

On Tue, Sep 18, 2018 at 11:02:54AM -0700, Jae Hyun Yoo wrote:

quoted

On 9/10/2018 2:45 PM, Jae Hyun Yoo wrote:

quoted

+- idle-wait-timeout-ms	: bus idle waiting timeout in milliseconds when
+			  multi-master is set, defaults to 100 ms when not
+			  specified.

Will change it to 'aspeed,idle-wait-timeout-ms' as it's a non standard
property.

No need. This binding is not a HW description, so not a DT property in
my book. I still don't understand: Your IP core in master mode does not
have a BUSY bit or similar which detects when a START was detected and
clears after a STOP?

Okay, I'll keep this property as it is then.

Sorry for the misunderstanding. I don't think this a property, at all.
It doesn't describe the hardware, it is more of a configuration thing,
or?

You are right. It doesn't describe the hardware but it needs to be
configurable because it very depends on the peer master's behavior.
If peer master sends a long packet usually, it should have a long
timeout value since a slave receiving operation takes long time,
and it should be adjusted with an optimal value with taking some
experiments to make it not too long. Any suggestion?

Thanks,
Jae