Hi Lothar,

-----Original Message-----
From: Lothar Wa?mann [mailto:LW at KARO-electronics.de]
Sent: Friday, August 31, 2018 5:28 PM
To: Yogesh Narayan Gaur <redacted>
Cc: linux-mtd at lists.infradead.org; boris.brezillon at bootlin.com;
marek.vasut at gmail.com; linux-spi at vger.kernel.org;
devicetree at vger.kernel.org; mark.rutland at arm.com; robh at kernel.org; linux-
kernel at vger.kernel.org; frieder.schrempf at exceet.de;
computersforpeace at gmail.com; shawnguo at kernel.org; linux-arm-
kernel at lists.infradead.org
Subject: Re: [PATCH 1/7] spi: add slave device size in spi_device struct

Hi,

On Fri, 31 Aug 2018 15:59:58 +0530 Yogesh Gaur wrote:

quoted

Add 'size' data variable in spi_device struct.
This is to save the size of the connected slave device.

After slave device scan, spi_nor_scan, size being assigned to this
from MTD layer.

SFDP read is being requested before completion of spi_nor_scan()
routine, thus populate device size before making read request to the
SPI controller.

Signed-off-by: Yogesh Gaur <redacted>
---
 drivers/mtd/devices/m25p80.c  | 6 ++++++
drivers/mtd/spi-nor/spi-nor.c | 2 ++
 include/linux/spi/spi.h       | 2 ++
 3 files changed, 10 insertions(+)

diff --git a/drivers/mtd/devices/m25p80.c

b/drivers/mtd/devices/m25p80.c index fe260cc..6c7ad86 100644

--- a/drivers/mtd/devices/m25p80.c
+++ b/drivers/mtd/devices/m25p80.c

@@ -124,6 +124,10 @@ static ssize_t m25p80_read(struct spi_nor *nor,

loff_t from, size_t len,

quoted

 	/* convert the dummy cycles to the number of bytes */
 	op.dummy.nbytes = (nor->read_dummy * op.dummy.buswidth) / 8;

+	/* for case of SFDP header read commands, populate spi device size */
+	if (flash->spimem->spi->size == 0)
+		flash->spimem->spi->size = nor->mtd.size;
+

If the 'size' is an spimem specific variable it should be added to the spi_mem
struct rather than the spi_device struct.

Sure, would move 'size' from struct spi_device to the struct spi_mem.

--
Regards
Yogesh Gaur.

Lothar Wa?mann