Hi Rob and Maxime,

On 08/27/2018 06:11 PM, Maxime Ripard wrote:

On Fri, Aug 24, 2018 at 10:35:23AM -0500, Rob Herring wrote:

quoted

On Fri, Aug 24, 2018 at 9:51 AM Georgi Djakov [off-list ref] wrote:

quoted

Hi Maxime,

On 08/20/2018 06:32 PM, Maxime Ripard wrote:

quoted

Hi Georgi,

On Tue, Aug 07, 2018 at 05:54:38PM +0300, Georgi Djakov wrote:

quoted

quoted

There is also a patch series from Maxime Ripard that's addressing the
same general area. See "dt-bindings: Add a dma-parent property". We
don't need multiple ways to address describing the device to memory
paths, so you all had better work out a common solution.

Looks like this fits exactly into the interconnect API concept. I see
MBUS as interconnect provider and display/camera as consumers, that
report their bandwidth needs. I am also planning to add support for
priority.

Thanks for working on this. After looking at your serie, the one thing
I'm a bit uncertain about (and the most important one to us) is how we
would be able to tell through which interconnect the DMA are done.

This is important to us since our topology is actually quite simple as
you've seen, but the RAM is not mapped on that bus and on the CPU's,
so we need to apply an offset to each buffer being DMA'd.

Ok, i see - your problem is not about bandwidth scaling but about using
different memory ranges by the driver to access the same location. So
this is not really the same and your problem is different. Also the
interconnect bindings are describing a path and endpoints. However i am
open to any ideas.

It may be different things you need, but both are related to the path
between a bus master and memory. We can't have each 'problem'
described in a different way. Well, we could as long as each platform
has different problems, but that's unlikely.

It could turn out that the only commonality is property naming
convention, but that's still better than 2 independent solutions.

Yeah, I really don't think the two issues are unrelated. Can we maybe
have a particular interconnect-names value to mark the interconnect
being used to perform DMA?

We can call one of the paths "dma" and use it to perform DMA for the
current device. I don't see a problem with this. The name of the path is
descriptive and makes sense. And by doing we avoid adding more DT
properties, which would be an other option.

This also makes me think that it might be a good idea to have a standard
name for the path to memory as i expect some people will call it "mem",
others "ddr" etc.

Thanks,
Georgi

quoted

I know you each want to just fix your issues, but the fact that DT
doesn't model the DMA side of the bus structure has been an issue at
least since the start of DT on ARM. Either we should address this in a
flexible way or we can just continue to manage without. So I'm not
inclined to take something that only addresses one SoC family.

I'd really like to have it addressed. We're getting bit by this, and
the hacks we have don't work well anymore.