Hi Song,

On 08/21/2018 10:53 AM, Ravi Bangoria wrote:

Hi Song,

quoted

However, if I start a.out AFTER enabling the uprobe, there is something wrong:

root at virt-test:~# ~/a.out
11
semaphore 0       <<< this should be non-zero, as the uprobe is already enabled

In this testcase, semaphore variable is stored into .bss:

  $ nm test | grep semaphore
  0000000010010c5e B semaphore
 
  $ readelf -SW ./test | grep "data\|bss"
    [22] .data             PROGBITS        0000000010010c58 000c58 000004 00  WA  0   0  1
    [23] .bss              NOBITS          0000000010010c5c 000c5c 000004 00  WA  0   0  2

I'm not so sure but I guess .bss data initialization happens after
calling uprobe_mmap() and thus you are seeing semaphore as 0.

To verify this, if I force to save semaphore into data section by
assigning non-zero value to it:

  volatile short semaphore = 1

 $ nm test | grep semaphore
 0000000010010c5c D semaphore

 $ readelf -SW ./test | grep "data\|bss"
    [22] .data             PROGBITS        0000000010010c58 000c58 000006 00  WA  0   0  2
    [23] .bss              NOBITS          0000000010010c5e 000c5e 000002 00  WA  0   0  1 

increment/decrement works fine.

Ravi