Hi Richard,

On Thu, Aug 09, 2018 at 10:47:17AM +0200, Richard Genoud wrote:

Hi !

On 07/08/2018 15:00, Ludovic Desroches wrote:

quoted

From: Nicolas Ferre <nicolas.ferre@microchip.com>

When mode is set in atmel_config_iso7816() we backup last RS232 mode
for coming back to this mode if requested.
Also allow setup of T=0 and T=1 parameter and basic support in set_termios
function as well.

Signed-off-by: Nicolas Ferre <nicolas.ferre@microchip.com>
[ludovic.desroches at microchip.com: rebase, add check on fidi ratio, checkpatch fixes]
Signed-off-by: Ludovic Desroches <ludovic.desroches@microchip.com>
---
 drivers/tty/serial/atmel_serial.c | 211 +++++++++++++++++++++++++++++++++++---
 drivers/tty/serial/atmel_serial.h |   6 +-
 2 files changed, 201 insertions(+), 16 deletions(-)

diff --git a/drivers/tty/serial/atmel_serial.c b/drivers/tty/serial/atmel_serial.c
index 8e4428725848..4a7ec44b0ace 100644
--- a/drivers/tty/serial/atmel_serial.c
+++ b/drivers/tty/serial/atmel_serial.c

[...]

quoted

 #if defined(CONFIG_OF)
+static struct atmel_uart_pdata at91rm9200_pdata = {
+	.fidi_min = 1,
+	.fidi_max = 2047,
+};
+
+static struct atmel_uart_pdata at91sam9260_pdata = {
+	.fidi_min = 1,
+	.fidi_max = 2047,
+};
+
+static struct atmel_uart_pdata sama5d3_pdata = {
+	.fidi_min = 3,
+	.fidi_max = 65535,

Are you sure this is for sama5d3 ?
From the datasheets I have, 65535 is for sama5d4/sama5d2

I checked it and I missed it. What a pity... In fact, it's a bit more
tricky since the min value for d3 is 3 and no longer 1.

And also, you'll have to s/atmel,at91sam9260-usart/atmel,sama5d2-usart/g
in sama5d{2,4}.dtsi

Yes, I planed to send it later but I can add those patches within this
set of patches. 

But I wonder if it could be detected via ATMEL_US_VERSION instead ?

I have not checked, I tend to prefer the compatible string for this kind
of thing. But as we already use the version number, I can investigate
this solution if it's the one you prefer.


Regards

Ludovic