[PATCH net-next 2/5] net: gemini: Improve connection prints
From: Linus Walleij <hidden>
Date: 2018-06-30 16:18:03
Also in:
netdev
Subsystem:
arm/cortina systems gemini arm architecture, networking drivers, the rest · Maintainers:
Hans Ulli Kroll, Linus Walleij, Andrew Lunn, "David S. Miller", Eric Dumazet, Jakub Kicinski, Paolo Abeni, Linus Torvalds
Instead of just specify that a PHY is connected at some speed, also specify which one. This is helpful with several PHYs on the system. Signed-off-by: Linus Walleij <redacted> --- drivers/net/ethernet/cortina/gemini.c | 13 ++++++++----- 1 file changed, 8 insertions(+), 5 deletions(-)
diff --git a/drivers/net/ethernet/cortina/gemini.c b/drivers/net/ethernet/cortina/gemini.c
index 8fc31723f700..b49ed8964026 100644
--- a/drivers/net/ethernet/cortina/gemini.c
+++ b/drivers/net/ethernet/cortina/gemini.c@@ -300,23 +300,26 @@ static void gmac_speed_set(struct net_device *netdev) status.bits.speed = GMAC_SPEED_1000; if (phydev->interface == PHY_INTERFACE_MODE_RGMII) status.bits.mii_rmii = GMAC_PHY_RGMII_1000; - netdev_info(netdev, "connect to RGMII @ 1Gbit\n"); + netdev_info(netdev, "connect %s to RGMII @ 1Gbit\n", + phydev_name(phydev)); break; case 100: status.bits.speed = GMAC_SPEED_100; if (phydev->interface == PHY_INTERFACE_MODE_RGMII) status.bits.mii_rmii = GMAC_PHY_RGMII_100_10; - netdev_info(netdev, "connect to RGMII @ 100 Mbit\n"); + netdev_info(netdev, "connect %s to RGMII @ 100 Mbit\n", + phydev_name(phydev)); break; case 10: status.bits.speed = GMAC_SPEED_10; if (phydev->interface == PHY_INTERFACE_MODE_RGMII) status.bits.mii_rmii = GMAC_PHY_RGMII_100_10; - netdev_info(netdev, "connect to RGMII @ 10 Mbit\n"); + netdev_info(netdev, "connect %s to RGMII @ 10 Mbit\n", + phydev_name(phydev)); break; default: - netdev_warn(netdev, "Not supported PHY speed (%d)\n", - phydev->speed); + netdev_warn(netdev, "Unsupported PHY speed (%d) on %s\n", + phydev->speed, phydev_name(phydev)); } if (phydev->duplex == DUPLEX_FULL) {
--
2.17.1