On Fri, May 25, 2018 at 07:12:38PM -0700, Andrey Smirnov wrote:

Make sure that MX51_PAD_GPIO1_1 does not remain configure as
ALT0/SD1_WP (it is out of reset). This is needed because of external
pull-up resistor attached to that pad that, when left unchanged, will
drive SD1_WP high preventing eSDHC1/eMMC from working correctly.

To fix that add a pinmux configuration line configureing the pad to
function as a GPIO. While we are at it, add a corresponding
output-high GPIO hog in an effort to minimize current consumption.

Cc: Nikita Yushchenko <nikita.yoush@cogentembedded.com>
Cc: Shawn Guo <shawnguo@kernel.org>
Cc: Fabio Estevam <redacted>
Cc: Lucas Stach <l.stach@pengutronix.de>
Cc: Chris Healy <redacted>
Cc: Rob Herring <robh+dt@kernel.org>
Cc: linux-arm-kernel at lists.infradead.org
Cc: devicetree at vger.kernel.org
Cc: linux-kernel at vger.kernel.org
Signed-off-by: Andrey Smirnov <redacted>

Applied, thanks.