On Wed, 28 Mar 2018, Thierry Reding wrote:

On Wed, Feb 14, 2018 at 11:04:31AM +0100, Fabrice Gasnier wrote:

quoted

This series adds support for capture to stm32-pwm driver.
Capture is based on DMAs.
- First two patches are precursor patches
- Subsequent two patches add support for requesting DMAs to MFD core
- Next three patches add support for capture to stm32-pwm driver
- This has been tested on stm32429i-eval board.

---
Resend v2:
- Add collected Acks

Changes in v2:
- Abstract DMA handling from child driver: move it to MFD core
- Rework pwm capture routines to adopt this change
- Comment on optional dma support, beautify DMAs probe

Fabrice Gasnier (8):
  pwm: stm32: fix, remove unused struct device
  pwm: stm32: protect common prescaler for all channels
  dt-bindings: mfd: stm32-timers: add support for dmas
  mfd: stm32-timers: add support for dmas
  pwm: stm32: add capture support
  pwm: stm32: improve capture by tuning counter prescaler
  pwm: stm32: use input prescaler to improve period capture
  ARM: dts: stm32: Enable pwm3 input capture on stm32f429i-eval

 .../devicetree/bindings/mfd/stm32-timers.txt       |  20 ++
 arch/arm/boot/dts/stm32429i-eval.dts               |   3 +
 drivers/mfd/stm32-timers.c                         | 215 +++++++++++++++-
 drivers/pwm/pwm-stm32.c                            | 276 ++++++++++++++++++++-
 include/linux/mfd/stm32-timers.h                   |  39 +++
 5 files changed, 547 insertions(+), 6 deletions(-)

I can't apply patches 1-2 and 5-6 since they depend on patches 3-4 for
which I'd need an Acked-by: from Lee if I'm to pick them up. Same goes
for patch 7.

By the looks of it there are minor conflicts with the MFD tree, but no
major ones. Perhaps it'd be better for Lee to pick up 3-4 for v4.17-rc1
and ack patch 7, then I can take the rest after v4.17-rc1?

Sounds like a faff.

Why don't I just pick them all up (except the ARM patch)?

-- 
Lee Jones [???]
Linaro Services Technical Lead
Linaro.org ? Open source software for ARM SoCs
Follow Linaro: Facebook | Twitter | Blog