[PATCH net-next 03/10] net: mvpp2: phylink support
From: linux@armlinux.org.uk (Russell King - ARM Linux)
Date: 2018-03-16 16:03:50
Also in:
lkml, netdev
On Fri, Mar 16, 2018 at 11:33:44AM +0100, Antoine Tenart wrote:
+static void mvpp2_phylink_validate(struct net_device *dev,
+ unsigned long *supported,
+ struct phylink_link_state *state)
+{
+ __ETHTOOL_DECLARE_LINK_MODE_MASK(mask) = { 0, };
+
+ phylink_set(mask, Autoneg);
+ phylink_set_port_modes(mask);
+ phylink_set(mask, Pause);
+ phylink_set(mask, Asym_Pause);
+
+ phylink_set(mask, 10baseT_Half);
+ phylink_set(mask, 10baseT_Full);
+ phylink_set(mask, 100baseT_Half);
+ phylink_set(mask, 100baseT_Full);
+ phylink_set(mask, 1000baseT_Full);
+ phylink_set(mask, 1000baseX_Full);AFAICS, the driver (before these patches) does not support 1000baseX as it always clears the MVPP2_GMAC_PORT_TYPE_MASK bit, so adding this mode should be part of the patch adding 1000baseX support. -- RMK's Patch system: http://www.armlinux.org.uk/developer/patches/ FTTC broadband for 0.8mile line in suburbia: sync at 8.8Mbps down 630kbps up According to speedtest.net: 8.21Mbps down 510kbps up