[linux-sunxi] [PATCH v3] ARM: sun8i: h2+: add support for Banana Pi M2 Zero board

On Sat, Feb 03, 2018 at 05:45:52PM +1100, Julian Calaby wrote:

Hi all,

On Sun, Dec 24, 2017 at 4:40 PM, Icenowy Zheng [off-list ref] wrote:

quoted

Banana Pi M2 Zero board is a H2+-based board by Sinovoip, with a form
factor and GPIO holes similar to Raspberry Pi Zero.

It features:
- Allwinner H2+ SoC
- Single-chip (16-bit) 512MiB DDR3 DRAM
- Ampak AP6212 Wi-Fi/Bluetooth module
- MicroSD slot
- Two MicroUSB Type-B ports (one can only be used to power the board and
  the other features OTG functionality)
- Two keys, a reset and a GPIO-connected key.
- HDMI Type-C (miniHDMI) connector connected to the HDMI part of H2+.
- CSI connector to connect the camera sensor provided by Sinovoip.

Signed-off-by: Icenowy Zheng <icenowy@aosc.io>

[Trimmed lots of non-sunxi-specific mailing lists]

Did support for this board ever get merged?

It doesn't look like it did.

(I have two of them now, so if it didn't, I'll try to shepherd this
and it's corresponding u-boot patch upstream.)

That sounds great :)

Maxime

-- 
Maxime Ripard, Bootlin (formerly Free Electrons)
Embedded Linux and Kernel engineering
http://bootlin.com
-------------- next part --------------
A non-text attachment was scrubbed...
Name: signature.asc
Type: application/pgp-signature
Size: 833 bytes
Desc: not available
URL: <http://lists.infradead.org/pipermail/linux-arm-kernel/attachments/20180205/3779c95c/attachment.sig>