On Tue, Feb 27, 2018 at 1:01 PM, Ard Biesheuvel
[off-list ref] wrote:

Add a binding and a driver for the I2C IP found in the Socionext SynQuacer
SoC, which is essentially a rebranded version of the Fujitsu F_I2C controller.

Thanks for an update!
FWIW,
Reviewed-by: Andy Shevchenko <redacted>

P.S. clk_prepare_enable() may fail in ->probe() as well.

v3:
- incorporate more of Andy's review comments (#2), especially regarding the
  bus speed and clock source handling for ACPI
- patch #1 unchanged.

v2:
- incorporate Andy's review comments (#2)
- patch #1 unchanged.

Ard Biesheuvel (2):
  dt-bindings: i2c: add binding for Socionext SynQuacer I2C
  i2c: add support for Socionext SynQuacer I2C controller

 Documentation/devicetree/bindings/i2c/i2c-synquacer.txt |  29 +
 drivers/i2c/busses/Kconfig                              |  10 +
 drivers/i2c/busses/Makefile                             |   1 +
 drivers/i2c/busses/i2c-synquacer.c                      | 787 ++++++++++++++++++++
 4 files changed, 827 insertions(+)
 create mode 100644 Documentation/devicetree/bindings/i2c/i2c-synquacer.txt
 create mode 100644 drivers/i2c/busses/i2c-synquacer.c

--
2.11.0

-- 
With Best Regards,
Andy Shevchenko