[PATCH v3 4/6] ARM: at91: Implement clocksource selection
From: alexandre.belloni@bootlin.com (Alexandre Belloni)
Date: 2018-02-23 17:16:22
Also in:
lkml
Subsystem:
arm port, arm/microchip (at91) soc support, the rest · Maintainers:
Russell King, Nicolas Ferre, Alexandre Belloni, Claudiu Beznea, Linus Torvalds
Allow selecting and unselecting the PIT clocksource driver so it doesn't have to be compile when unused. Signed-off-by: Alexandre Belloni <alexandre.belloni@bootlin.com> --- arch/arm/mach-at91/Kconfig | 25 +++++++++++++++++++++++++ 1 file changed, 25 insertions(+)
diff --git a/arch/arm/mach-at91/Kconfig b/arch/arm/mach-at91/Kconfig
index 6d870421a7a6..2d8ca72f9ecf 100644
--- a/arch/arm/mach-at91/Kconfig
+++ b/arch/arm/mach-at91/Kconfig@@ -106,6 +106,31 @@ config SOC_AT91SAM9 AT91SAM9X35 AT91SAM9XE +comment "Clocksource driver selection" + +config ATMEL_CLOCKSOURCE_PIT + bool "Periodic Interval Timer (PIT) support" + depends on SOC_AT91SAM9 || SOC_SAMA5 + default SOC_AT91SAM9 || SOC_SAMA5 + select ATMEL_PIT + help + Select this to get a clocksource based on the Atmel Periodic Interval + Timer. It has a relatively low resolution and the TC Block clocksource + should be preferred. + +config ATMEL_CLOCKSOURCE_TCB + bool "Timer Counter Blocks (TCB) support" + depends on SOC_AT91RM9200 || SOC_AT91SAM9 || SOC_SAMA5 || COMPILE_TEST + default SOC_AT91RM9200 || SOC_AT91SAM9 || SOC_SAMA5 + depends on !ATMEL_TCLIB + select ATMEL_ARM_TCB_CLKSRC + help + Select this to get a high precision clocksource based on a + TC block with a 5+ MHz base clock rate. + On platforms with 16-bit counters, two timer channels are combined + to make a single 32-bit timer. + It can also be used as a clock event device supporting oneshot mode. + config HAVE_AT91_UTMI bool
--
2.16.1