W dniu 20.02.2018 o?20:55, Stephen Warren pisze:

On 02/19/2018 01:16 PM, Tomasz Maciej Nowak wrote:

quoted

Adds device nodes for two front panel LEDs.

Why do you need to change the pinmux settings? Configuring a pin as a 
GPIO should override any pinmux special function selection and hence 
make it irrelevant, so I don't think you should need to change the pinmux.

At first I did exactly that without changing the pinmux, but the LEDs 
didn't light up. After that I compared with CompuLab source tree [1]. 
The pinmux was specified as in my patch. With this change the LEDs are 
fully functional.

1. 
https://gitorious.org/trimslice-kernel/trimslice-kernel?p=trimslice-kernel:trimslice-kernel.git;a=blob;f=arch/arm/mach-tegra/board-trimslice-pinmux.c;h=cc6d5225d97eb9327c820bf1d5b2bc16ab8c6dda;hb=d25bf45d6314089489b30d218ed8a0d6d94417f9#l45

-- 
Tomek