On 1 November 2017 at 12:05, Stefan Wahren [off-list ref] wrote:

Hi Matt, hi Peter,

Am 01.11.2017 um 10:37 schrieb Peter Robinson:

quoted

On Tue, Oct 31, 2017 at 5:00 PM, Matt Hart [off-list ref] wrote:

quoted

On 6 October 2017 at 23:14, Florian Fainelli [off-list ref] wrote:

quoted

On 10/06/2017 03:05 PM, Eric Anholt wrote:

quoted

Hi Florian.  Here's a patch that's gone through a couple of revisions
on the list, that seriously fixes up the default serial behavior --
previously, without the right config.txt/cmdline bits, you'd often end
up with a hang with no output before booting completed.  It would be
great to get it into 4.14.

The following changes since commit 2bd6bf03f4c1c59381d62c61d03f6cc3fe71f66e:

  Linux 4.14-rc1 (2017-09-16 15:47:51 -0700)

are available in the git repository at:

  git://github.com/anholt/linux tags/bcm2835-dt-fixes-2017-10-06

for you to fetch changes up to f08f58a2bf68900a84e782b8c7ad701c0654173c:

  ARM: dts: bcm283x: Fix console path on RPi3 (2017-10-06 13:04:56 -0700)

----------------------------------------------------------------
This pull request brings in a fix for default serial console setup on
RPi3, so it now comes up with no config.txt/cmdline.txt settings in
the firmware.

----------------------------------------------------------------

Merged, thanks Eric

--
Florian

Hi all,

I realise this patch has been in mainline for a more than a week, but
I've only recently had time to bisect broken rpi-3 boots in kernelci
and found f08f58a2bf68900a84e782b8c7ad701c0654173c as the cause.

Kernelci boots the rpi3 using uboot, with console=ttyS0 in the command
line which now fails:
https://kernelci.org/boot/id/59f787f059b5147794ef1dcf/

Is there an alias I can use for both before and after this patch?

Mainline boots fine if I use console=ttyS1 or drop the console arg
altogether, but as we don't currently support different boot args per
tree, and we don't have the manpower to track this patch in all the
trees we test, we will have to switch to only boot testing mainline
from now on.

Yes, I've seen the same in Fedora with that patch.

could you please describe the issue more in detail.

Does u-boot or Linux hang? Does u-boot select the wrong UART? Is there a
pinmux conflict?

Linux throws a kernel panic, "Warning: unable to open an initial console."

Which u-boot version do you use?

These are the 2 boot reports from KernelCI, there some LAVA debug in
there but you can see the uboot version and boot commands used.

Working boot
https://storage.kernelci.org/mainline/master/v4.14-rc5-95-g1c9fec470b81/arm64/defconfig/lab-mhart/boot-bcm2837-rpi-3-b.html

Failing boot
https://storage.kernelci.org/mainline/master/v4.14-rc5-125-g9c323bff13f9/arm64/defconfig/lab-mhart/boot-bcm2837-rpi-3-b.html

Best regards

Stefan

-- 
Matt Hart