[PATCH v2 3/4] dt-bindings: hwmon: Add ti-max-expected-current-microamp property to ina2xx

On 10/12/2017 03:55 PM, Guenter Roeck wrote:

On 10/12/2017 06:00 AM, Maciej Purski wrote:

quoted

On 10/12/2017 02:39 PM, Krzysztof Kozlowski wrote:

quoted

On Thu, Oct 12, 2017 at 2:36 PM, Maciej Purski [off-list ref] wrote:

quoted

Add optional max expected current property which allows calibrating
the ina sensor in order to achieve requested measure scale. Document
the changes in Documentation/hwmon/ina2xx.

Signed-off-by: Maciej Purski <redacted>
---
? Documentation/devicetree/bindings/hwmon/ina2xx.txt | 4 +++-
? Documentation/hwmon/ina2xx???????????????????????? | 3 +++
? 2 files changed, 6 insertions(+), 1 deletion(-)

diff --git a/Documentation/devicetree/bindings/hwmon/ina2xx.txt 

b/Documentation/devicetree/bindings/hwmon/ina2xx.txt
index 02af0d9..49ef0be 100644

--- a/Documentation/devicetree/bindings/hwmon/ina2xx.txt
+++ b/Documentation/devicetree/bindings/hwmon/ina2xx.txt

@@ -14,11 +14,13 @@ Optional properties:

? - shunt-resistor
???????? Shunt resistor value in micro-Ohm
-
+- ti-max-expected-current-microamp
+?????? Max expected current value in mA
? Example:

? ina220 at 44 {
???????? compatible = "ti,ina220";
???????? reg = <0x44>;
???????? shunt-resistor = <1000>;
+?????? ti-max-expected-current-microamp = <3000>;
? };

diff --git a/Documentation/hwmon/ina2xx b/Documentation/hwmon/ina2xx
index cfd31d9..30620e8 100644
--- a/Documentation/hwmon/ina2xx
+++ b/Documentation/hwmon/ina2xx

@@ -55,6 +55,9 @@ The shunt value in micro-ohms can be set via platform data 

or device tree at
? compile-time or via the shunt_resistor attribute in sysfs at run-time. Please
? refer to the Documentation/devicetree/bindings/i2c/ina2xx.txt for bindings
? if the device tree is used.
+The max expected current value in miliamp can be set via platform data

mili or micro?

BR,
Krzysztof

Sorry, these should be mili everywhere. I'll fix this.

You sure ? I think DT usually uses micro.

Guenter

Yeah, you're right. I was intending to make it milli, but I haven't checked that
all DTS use micro. Sorry for confusion.

Best Regards,

Maciej

quoted

quoted

quoted

+or device tree at compile-time or via currX_max attribute in sysfs
+at run-time.

? Additionally ina226 supports update_interval attribute as described in
? Documentation/hwmon/sysfs-interface. Internally the interval is the sum of
-- 
2.7.4