[PATCH 1/8] pinctrl: meson: remove offset from pinctrl

On Thu, 2017-10-05 at 13:22 +0200, Linus Walleij wrote:

On Wed, Sep 20, 2017 at 3:39 PM, Jerome Brunet [off-list ref] wrote:

quoted

Offset on meson pinctrl and gpios is something that was carried from the
vendor driver, where there is a weird link between the 2
controllers. Since these 2 controllers are independent, this offset adds
an unnecessary complexity.

This patch remove this manually set offset and rely on pinctrl to figure
out the gpio base offset

Tested-by: Martin Blumenstingl <martin.blumenstingl@googlemail.com>
Signed-off-by: Jerome Brunet <jbrunet@baylibre.com>

Patch applied.

Thx Linus.

Just to be sure, did you remember to squash patch 1 to 5 together ?

I know it is a bit unusual but, as explained earlier, those patches were only
split to ease the review. Keeping the change split would break bisect.

Yours,
Linus Walleij