[PATCH 01/10] dt-bindings: bus: Minimal TI sysc interconnect target module binding

* Matthijs van Duin [off-list ref] [170925 00:04]:

On Wed, Sep 20, 2017 at 03:46:12PM -0700, Tony Lindgren wrote:

quoted

TI sysc interconnect target module hardware is independent of the
interconnect. It is used at least with TI L3 interconnect (Arteris NoC)
and TI L4 interconnect (Sonics s3220).

This is because the interface between interconnect and module is
standardized (Open Core Protocol), so it doesn't really matter which
interconnect technology is used.

Also, afaik sysc mostly just concerns the interaction between module and
PRCM.  The only role the interconnect plays here is that it participates
in the OCP Disconnect Protocol to allow the module to safely disconnect
itself when it or the interconnect enters idle state.

OK thanks for clarifying it, I'll add a note regarding OCP there.

Regards,

Tony