[PATCH v2 2/9] dt-bindings: serial/rs485: make rs485-rts-delay optional
From: Uwe Kleine-König <hidden>
Date: 2017-06-23 09:49:38
Also in:
linux-devicetree, linux-serial
Subsystem:
open firmware and flattened device tree bindings, the rest, tty layer and serial drivers · Maintainers:
Rob Herring, Krzysztof Kozlowski, Conor Dooley, Linus Torvalds, Greg Kroah-Hartman, Jiri Slaby
There are a few device trees that specify one of the already optional properties without also having the up to now required property rs485-rts-delay. Additionally there is no technical reason to require rs485-rts-delay and that's also what most drivers implement. So give existing users and implementers a blessing and document rs485-rts-delay as optional. Signed-off-by: Uwe Kleine-K?nig <redacted> --- This is new in v2 and implements the binding update making rs485-rts-delay optional as suggested by Sascha. Documentation/devicetree/bindings/serial/rs485.txt | 5 ++--- 1 file changed, 2 insertions(+), 3 deletions(-)
diff --git a/Documentation/devicetree/bindings/serial/rs485.txt b/Documentation/devicetree/bindings/serial/rs485.txt
index 32b1fa1f2a5b..b8415936dfdb 100644
--- a/Documentation/devicetree/bindings/serial/rs485.txt
+++ b/Documentation/devicetree/bindings/serial/rs485.txt@@ -5,14 +5,13 @@ the built-in half-duplex mode. The properties described hereafter shall be given to a half-duplex capable UART node. -Required properties: +Optional properties: - rs485-rts-delay: prop-encoded-array <a b> where: * a is the delay between rts signal and beginning of data sent in milliseconds. it corresponds to the delay before sending data. * b is the delay between end of data sent and rts signal in milliseconds it corresponds to the delay after sending data and actual release of the line. - -Optional properties: + If this property is not specified, <0 0> is assumed. - linux,rs485-enabled-at-boot-time: empty property telling to enable the rs485 feature at boot time. It can be disabled later with proper ioctl. - rs485-rx-during-tx: empty property that enables the receiving of data even
--
2.11.0