[PATCH RFC 5/5] ARM: dts: vf-colibri-eval: use IRQ_TYPE_* to specify irq flags

According to the binding documentation and the source code the
vf610-gpio controller takes IRQ_TYPE_* as its flags values, not
GPIO_ACTIVE_*.

This patch uses the right variable type which yields the same result
when compiled. Note that this might be wrong and actually
IRQ_TYPE_LEVEL_LOW is intended by the dt author.

Signed-off-by: Uwe Kleine-K?nig <redacted>
---
Hello,

can somebody with the hardware or it's documentation please check which
flag is the right one?

Best regards
Uwe

 arch/arm/boot/dts/vf-colibri-eval-v3.dtsi | 2 +-
 1 file changed, 1 insertion(+), 1 deletion(-)

diff --git a/arch/arm/boot/dts/vf-colibri-eval-v3.dtsi b/arch/arm/boot/dts/vf-colibri-eval-v3.dtsi
index 091b738041a0..3e0c84d79c43 100644
--- a/arch/arm/boot/dts/vf-colibri-eval-v3.dtsi
+++ b/arch/arm/boot/dts/vf-colibri-eval-v3.dtsi

@@ -117,7 +117,7 @@
 		clocks = <&clk16m>;
 		spi-max-frequency = <10000000>;
 		interrupt-parent = <&gpio1>;
-		interrupts = <11 GPIO_ACTIVE_LOW>;
+		interrupts = <11 IRQ_TYPE_EDGE_RISING>;
 	};
 };
 

-- 
2.11.0