[PATCH 2/4] dt-bindings: thermal: add binding documentation for UniPhier thermal monitor
From: hayashi.kunihiko@socionext.com (Kunihiko Hayashi)
Date: 2017-05-29 09:17:15
Also in:
linux-devicetree, linux-pm, lkml
Subsystem:
open firmware and flattened device tree bindings, the rest, thermal · Maintainers:
Rob Herring, Krzysztof Kozlowski, Conor Dooley, Linus Torvalds, Rafael J. Wysocki, Daniel Lezcano
Add devicetree binding documentation for thermal monitor implemented on Socionext UniPhier SoCs. Signed-off-by: Kunihiko Hayashi <hayashi.kunihiko@socionext.com> --- .../bindings/thermal/uniphier-thermal.txt | 54 ++++++++++++++++++++++ 1 file changed, 54 insertions(+) create mode 100644 Documentation/devicetree/bindings/thermal/uniphier-thermal.txt
diff --git a/Documentation/devicetree/bindings/thermal/uniphier-thermal.txt b/Documentation/devicetree/bindings/thermal/uniphier-thermal.txt
new file mode 100644
index 0000000..72834e1
--- /dev/null
+++ b/Documentation/devicetree/bindings/thermal/uniphier-thermal.txt@@ -0,0 +1,54 @@ +* UniPhier Thermal bindings + +This describes the devicetree bindings for thermal monitor supported by +PVT(Process, Voltage and Temperature) monitoring unit implemented on Socionext +UniPhier SoCs. + +Required properties: +- compatible : + - "socionext,uniphier-pxs2-thermal" : For UniPhier PXs2 SoC + - "socionext,uniphier-ld20-thermal" : For UniPhier LD20 SoC +- reg : Offset address of the thermal registers from sysctrl +- interrupts : IRQ for the temperature alarm +- #thermal-sensor-cells : Should be 0. See ./thermal.txt for details. + +Optional properties: +- socionext,tmod-calibration: A pair of calibrated values referred from PVT, + in case that the values aren't set on SoC, + like a reference board. + +Example: + + sysctrl at 61840000 { + compatible = "socionext,uniphier-ld20-sysctrl", + "simple-mfd", "syscon"; + reg = <0x61840000 0x10000>; + ... + pvtctl: pvtctl { + compatible = "socionext,uniphier-ld20-thermal"; + interrupts = <0 3 1>; + #thermal-sensor-cells = <0>; + }; + ... + }; + + thermal-zones { + cpu_thermal { + polling-delay-passive = <250>; /* 250ms */ + polling-delay = <1000>; /* 1000ms */ + thermal-sensors = <&pvtctl>; + + trips { + cpu_crit: cpu_crit { + temperature = <95000>; /* 95C */ + hysteresis = <2000>; + type = "critical"; + }; + cpu_alert: cpu_alert { + temperature = <85000>; /* 85C */ + hysteresis = <2000>; + type = "passive"; + }; + }; + }; + };
--
2.7.4