[PATCH v2 08/20] ARM: dts: sun8i: Enable dwmac-sun8i on the Banana Pi M2+
From: clabbe.montjoie@gmail.com (Corentin Labbe)
Date: 2017-03-14 14:26:38
Also in:
linux-devicetree, lkml, netdev
Subsystem:
the rest · Maintainer:
Linus Torvalds
From: LABBE Corentin <clabbe.montjoie@gmail.com> The dwmac-sun8i hardware is present on the Banana Pi M2+ It uses an external PHY rtl8211e via RGMII. This patch create the needed regulator, emac and phy nodes. Signed-off-by: Corentin Labbe <clabbe.montjoie@gmail.com> --- arch/arm/boot/dts/sun8i-h3-bananapi-m2-plus.dts | 37 +++++++++++++++++++++++++ 1 file changed, 37 insertions(+)
diff --git a/arch/arm/boot/dts/sun8i-h3-bananapi-m2-plus.dts b/arch/arm/boot/dts/sun8i-h3-bananapi-m2-plus.dts
index 52acbe1..30b0a41 100644
--- a/arch/arm/boot/dts/sun8i-h3-bananapi-m2-plus.dts
+++ b/arch/arm/boot/dts/sun8i-h3-bananapi-m2-plus.dts@@ -90,6 +90,18 @@ pinctrl-0 = <&wifi_en_bpi_m2p>; reset-gpios = <&r_pio 0 7 GPIO_ACTIVE_LOW>; /* PL7 */ }; + + reg_gmac_3v3: gmac-3v3 { + compatible = "regulator-fixed"; + pinctrl-names = "default"; + pinctrl-0 = <&gmac_power_pin_orangepi>; + regulator-name = "gmac-3v3"; + regulator-min-microvolt = <3300000>; + regulator-max-microvolt = <3300000>; + startup-delay-us = <100000>; + enable-active-high; + gpio = <&pio 3 6 GPIO_ACTIVE_HIGH>; + }; }; &ehci1 {
@@ -186,3 +198,28 @@ /* USB VBUS is on as long as VCC-IO is on */ status = "okay"; }; + +&pio { + gmac_power_pin_orangepi: gmac_power_pin at 0 { + pins = "PD6"; + function = "gpio_out"; + drive-strength = <10>; + }; +}; + +&mdio { + ext_rgmii_phy: ethernet-phy at 1 { + reg = <0>; + }; +}; + +&emac { + pinctrl-names = "default"; + pinctrl-0 = <&emac_rgmii_pins>; + phy-supply = <®_gmac_3v3>; + phy-handle = <&ext_rgmii_phy>; + phy-mode = "rgmii"; + + allwinner,leds-active-low; + status = "okay"; +};
--
2.10.2