[PATCH] serial: imx: Only enable UART DMA on i.MX6Q and i.MX53

On 02/06/2017 08:38 PM, Fabio Estevam wrote:

Hi Marek,

Hi,

On Mon, Feb 6, 2017 at 5:05 PM, Marek Vasut [off-list ref] wrote:

quoted

Well yes, DMA is broken in 4.9 , that's why it's CC stable 4.9+ :)

This patch is based on the fact that the UART on the imx6sx is not of
a imx6q UART type, which is not correct.

Current imx6sx.dtsi misses to add a "fsl,imx6q-uart" compatible
string, just like all other imx6 SoC dtsi.

Well given that the DMA does not work on 6SX, I guess it's not really
compatible with 6Q.

When we fix the compatible uart problem on imx6sx.dtsi, then DMA will
be enabled and things will break again.

That's why we need a better fix for this issue:

1) Let's see if Clemens' suggestion of using the latest SDMA firmware
can make DMA robust on  your usecase.

a) This will break if you don't use the latest SDMA firmware. This can
   be repaired by checking the SDMA firmware version and selectively
   disabling the DMA for broken versions.
b) The DMA should not have been enabled on 4.9 , but it incorrectly is.
   Enabling it on 4.9 is a feature addition, which shouldn't go into
   stable kernel.

2) If the system fails even with the latest SDMA, then the board dts
can disable dma by passing empty dma nodes.

This might actually be the thing to do for 4.9 if you want to add the
mx6q compatible to mx6sx uart .

Not all mx6 system seem to suffer from such SDMA problem. On a
imx6sx-udoo-neo we could use UART with DMA to connect to the Bluetooth
chip.

Clearly some do, so it's probably also a matter of the link partner
behavior.

-- 
Best regards,
Marek Vasut