[PATCH V9] thermal: bcm2835: add thermal driver for bcm2835 soc

Hello Martin,

On Sat, Jan 07, 2017 at 04:55:45PM +0000, kernel at martin.sperl.org wrote:

From: Martin Sperl <redacted>

Add basic thermal driver for bcm2835 SOC.

This driver currently relies on the firmware setting up the
tsense HW block and does not set it up itself.

Signed-off-by: Martin Sperl <redacted>
Acked-by: Eric Anholt <redacted>
Acked-by: Stefan Wahren <redacted>

<cut>

+
+static const struct of_device_id bcm2835_thermal_of_match_table[] = {
+	{
+		.compatible = "brcm,bcm2835-thermal",
+		.data = &(struct bcm2835_thermal_info) {
+			.offset = 407000,
+			.slope = -538,
+			.trip_temp = 80000
+		}
+	},
+	{
+		.compatible = "brcm,bcm2836-thermal",
+		.data = &(struct bcm2835_thermal_info) {
+			.offset = 407000,
+			.slope = -538,
+			.trip_temp = 80000
+		}
+	},
+	{
+		.compatible = "brcm,bcm2837-thermal",
+		.data = &(struct bcm2835_thermal_info) {
+			/* the bcm2837 needs adjustment of +5C */
+			.offset = 407000 + 5000,
+			.slope = -538,
+			.trip_temp = 80000
+		}
+	},
+	{},

Just for the same of clarification, is there anything preventing this
driver of using of-thermal API? the above data (slope, offset, and
trip_temps) would be in DT the place where they are supposed to be,
instead of code.

+};
+MODULE_DEVICE_TABLE(of, bcm2835_thermal_of_match_table);
+
+static struct platform_driver bcm2835_thermal_driver = {
+	.probe = bcm2835_thermal_probe,
+	.remove = bcm2835_thermal_remove,
+	.driver = {
+		.name = "bcm2835_thermal",
+		.of_match_table = bcm2835_thermal_of_match_table,
+	},
+};
+module_platform_driver(bcm2835_thermal_driver);
+
+MODULE_AUTHOR("Martin Sperl");
+MODULE_DESCRIPTION("Thermal driver for bcm2835 chip");
+MODULE_LICENSE("GPL");
--
2.1.4