On Fri, Jan 06, 2017 at 06:11:24PM -0800, Steve Longerbeam wrote:

+	ov5640: camera at 40 {
+		compatible = "ovti,ov5640";
+		pinctrl-names = "default";
+		pinctrl-0 = <&pinctrl_ov5640>;
+		clocks = <&mipi_xclk>;
+		clock-names = "xclk";
+		reg = <0x40>;
+		xclk = <22000000>;
+		reset-gpios = <&gpio2 5 GPIO_ACTIVE_LOW>; /* NANDF_D5 */
+		pwdn-gpios = <&gpio6 9 GPIO_ACTIVE_HIGH>; /* NANDF_WP_B */
+
+		port {
+			#address-cells = <1>;
+			#size-cells = <0>;
+
+			ov5640_to_mipi_csi: endpoint at 1 {
+				reg = <1>;
+				remote-endpoint = <&mipi_csi_from_mipi_sensor>;
+				data-lanes = <0 1>;
+				clock-lanes = <2>;

How do you envision a four-lane sensor being described?

	data-lanes = <0 1 3 4>;
	clock-lanes = <2>;

?

The binding document for video-interfaces.txt says:

- clock-lanes: an array of physical clock lane indexes. Position of an entry
  determines the logical lane number, while the value of an entry indicates
  physical lane, e.g. for a MIPI CSI-2 bus we could have "clock-lanes = <0>;",
  which places the clock lane on hardware lane 0. This property is valid for
  serial busses only (e.g. MIPI CSI-2). Note that for the MIPI CSI-2 bus this
  array contains only one entry.

So I think you need to have a good reason to make the clock lane non-zero.

-- 
RMK's Patch system: http://www.armlinux.org.uk/developer/patches/
FTTC broadband for 0.8mile line: currently at 9.6Mbps down 400kbps up
according to speedtest.net.