[PATCH net-next v6 4/4] phy: marvell: Add support for the PHY embedded in the topaz switch

Hi Andrew,
 
 On mar., janv. 24 2017, Andrew Lunn [off-list ref] wrote:

On Tue, Jan 24, 2017 at 09:10:26PM +0100, Gregory CLEMENT wrote:

quoted

The PHY with the ID 0x1410C00

:-(

I don't have a better reference, but
Linux/Documentation/devicetree/bindings/net/phy.txt says:

 22   If the phy's identifier is known then the list may contain an entry
 23   of the form: "ethernet-phy-idAAAA.BBBB" where
 24      AAAA - The value of the 16 bit Phy Identifier 1 register as
 25             4 hex digits. This is the chip vendor OUI bits 3:18
 26      BBBB - The value of the 16 bit Phy Identifier 2 register as
 27             4 hex digits. This is the chip vendor OUI bits 19:24,
 28             followed by 10 bits of a vendor specific ID.

So the lower 10 bits of 0x1410C00 are 0. So we know it is a Marvell
PHY from the OUI, but the vendor specific bits are all 0.

In your previous email you mention a value of 0x01410000, so when I saw
the "C00" at the end I was happy and I didn't look for further.

Please take a look at:

https://marc.info/?l=linux-netdev&m=148495522620757&w=1

and

https://marc.info/?l=linux-netdev&m=148495510320714&w=1

Maybe i should submit these two independently, so you can extend it
for the 88E6341 family.

Please do it :)

The feedback from Florian and Vivian was good about it so I see no
reason to not apply them.

Add me in CC so I will now when to rebase my series.

Thanks,

Gregory

    Andrew

-- 
Gregory Clement, Free Electrons
Kernel, drivers, real-time and embedded Linux
development, consulting, training and support.
http://free-electrons.com