[PATCH 25/37] dt-bindings: PCI: Add dt bindings for pci designware EP mode
From: Kishon Vijay Abraham I <hidden>
Date: 2017-01-12 10:31:32
Also in:
linux-arm-msm, linux-devicetree, linux-omap, linux-pci, linux-samsung-soc, linuxppc-dev, lkml
Subsystem:
open firmware and flattened device tree bindings, pci native host bridge and endpoint drivers, pci subsystem, the rest · Maintainers:
Rob Herring, Krzysztof Kozlowski, Conor Dooley, Lorenzo Pieralisi, Krzysztof Wilczyński, Manivannan Sadhasivam, Bjorn Helgaas, Linus Torvalds
Add device tree binding documentation for pci designware EP mode. Signed-off-by: Kishon Vijay Abraham I <redacted> --- .../devicetree/bindings/pci/designware-pcie.txt | 26 ++++++++++++++------ 1 file changed, 18 insertions(+), 8 deletions(-)
diff --git a/Documentation/devicetree/bindings/pci/designware-pcie.txt b/Documentation/devicetree/bindings/pci/designware-pcie.txt
index 1392c70..b2480dd 100644
--- a/Documentation/devicetree/bindings/pci/designware-pcie.txt
+++ b/Documentation/devicetree/bindings/pci/designware-pcie.txt@@ -6,30 +6,40 @@ Required properties: - reg-names: Must be "config" for the PCIe configuration space. (The old way of getting the configuration address space from "ranges" is deprecated and should be avoided.) +- num-lanes: number of lanes to use +RC mode: - #address-cells: set to <3> - #size-cells: set to <2> - device_type: set to "pci" - ranges: ranges for the PCI memory and I/O regions - #interrupt-cells: set to <1> -- interrupt-map-mask and interrupt-map: standard PCI properties - to define the mapping of the PCIe interface to interrupt +- interrupt-map-mask and interrupt-map: standard PCI + properties to define the mapping of the PCIe interface to interrupt numbers. -- num-lanes: number of lanes to use +EP mode: +- num-ib-windows: number of inbound address translation + windows +- num-ob-windows: number of outbound address translation + windows Optional properties: -- num-viewport: number of view ports configured in hardware. If a platform - does not specify it, the driver assumes 2. - num-lanes: number of lanes to use (this property should be specified unless the link is brought already up in BIOS) - reset-gpio: gpio pin number of power good signal -- bus-range: PCI bus numbers covered (it is recommended for new devicetrees to - specify this property, to keep backwards compatibility a range of 0x00-0xff - is assumed if not present) - clocks: Must contain an entry for each entry in clock-names. See ../clocks/clock-bindings.txt for details. - clock-names: Must include the following entries: - "pcie" - "pcie_bus" +RC mode: +- num-viewport: number of view ports configured in + hardware. If a platform does not specify it, the driver assumes 2. +- bus-range: PCI bus numbers covered (it is recommended + for new devicetrees to specify this property, to keep backwards + compatibility a range of 0x00-0xff is assumed if not present) +EP mode: +- max-functions: maximum number of functions that can be + configured Example configuration:
--
1.7.9.5